Electrical modeling of dielectric barrier discharge considering surface charge on the plasma modified material

We present the variations of electrical parameters of dielectric barrier discharge(DBD)when the DBD generator is used for the material modification,whereas the relevant physical mechanism is also elaborated.An equivalent circuit model is applied for a DBD generator working in a filament discharging mode,considering the addition of epoxy resin(EP)as the plasma modified material.The electrical parameters are calculated through the circuit model.The surface conductivity,surface potential decay,trap distributions and surface charge distributions on the EP surface before and after plasma treatments were measured and calculated.It is found that the coverage area of micro-discharge channels on the EP surface is increased with the discharging time under the same applied AC voltage.The results indicate that the plasma modified material could influence the ignition of new filaments in return during the modification process.Moreover,the surface conductivity and density of shallow traps with low trap energy of the EP samples increase after the plasma treatment.The surface charge distributions indicate that the improved surface properties accelerate the movement and redistribution of charge carriers on the EP surface.The variable electrical parameters of discharge are attributed to the redistribution of deposited surface charge on the plasma modified EP sample surface.