基于UG NX的锚曲面建模方法应用研究

Application Research of Anchor Surface Modeling Method Based on UG NX

针对复杂曲面的特点,以锚的曲面作为研究对象,使用UGNX软件的"通过曲线网格"和"填充曲面"两种命令分别建模,对曲面建模效果进行分析比较,并介绍了曲面建模及曲面优化的方法;最后总结了"通过曲线网格"和"填充曲面"两种命令在复杂曲面建模时的技巧。

According to the characteristics of complex surface,the anchor surface is taken as the research object,and the"through curve mesh"and"fill surface"commands of UGNX software are used to model respectively,and the surface modeling effect is analyzed and compared,and the methods of surface modeling and surface optimization are introduced.Finally,the skills of"through curve mesh"and"fill surface"commands in complex surface modeling are summarized.