基于Demo3D仿真的四线一库设计方法和应用

Design Method and Application of Assembly Lines and Intelligent Warehouse Based on Demo3D Simulation

[目的]为了进一步优化四线一库的设计工作,提出了一种基于Demo3D仿真的四线一库勘察设计方法,该方法在保证方案先进性、完整性、正确性等前提下,尽可能降低设计人员工作强度。[方法]该方法完成四线一库的设计输入收集、基础参数计算、流水线关键参数计算、智能立库关键参数计算、仿真输入参数计算、仿真设计工作、仿真输出工作和导出设计成果等八部分主要工作。[结果]该方法为建设单位、设计人员、设备厂家、施工单位等多方主体提供相关技术支撑,提升方案和数据流转过程的效率和正确率。[结论]该方法逐步投入到多地区实际设计工作中,得到了实际工作的充分验证和应用,证明所提方法是切实可行的,并为实际应用提供指导和关键技术支撑。

[Introduction]In order to further optimize the design of meter testing and storage,this paper proposes a Demo3D simulation based survey and design method of the“intelligent meter testing line and storage system”,which reduces the work intensity of designers as much as possible on the premise of guaranteeing the advancement,integrity and correctness of the scheme.[Method]The method included basic design input data collection,parameter calculation,testing line key parameters calculaiton,Intelligent warehouse key parameters calculation,simulation input parameters calculation,simulation design work,simulation output work and output design results.[Result]This method provides relevant technical support for construction units,designers,equipment manufacturers and construction units,and improves the efficiency and correctness of the scheme and data flow process.[Conclusion]This proposed method is gradually put into the practical design work in many areas,and has been fully verified and applied in practical work,which proves that the method is feasible,and provides guidance and key technical support for practical application.