摘要
为了优化JCOE成型工艺,通过对板材压弯过程进行分析得出挠度与力之间的公式。在Abaqus软件中建立JCOE成型过程模型并进行有限元分析。结果表明,理论公式与模拟结果一致,验证了模型的合理性,提高了成型精度。
To optimize the forming process of JCOE, the formula between deflection and force was obtained by analyzing the plate bending process. In Abaqus software, JCOE forming process model was established and finite element analysis was carried out. The results showed that the theoretical formula was consistent with the simulation results, which verified the rationality of the model and improved the forming accuracy.
作者
武于善
王永建
魏晓晋
刘宝胜
李岩
张芳萍
Wu Yushan;Wang Yongjian;Wei Xiaojin;Liu Baosheng;Li Yan;Zhang Fangping(Sinosteel Stainless Steel Pipe Technology Shanxi Co.,Ltd.,Jingzhong Shanxi 030600;Taiyuan University of Science and Technology,Taiyuan Shanxi 030024)
出处
《山西冶金》
CAS
2020年第4期29-30,共2页
Shanxi Metallurgy
基金
2018年山西省重点研发计划项目“军民融合项目-海洋领域用特种合金焊管工艺研发及制造”(201803D121129)
2018年晋中市科技重点研发计划“军民融合项目-海洋领域用特种合金焊管工艺研发及制造”(Y191004)
2019年山西转型综合改革示范区晋中开发区科技攻关计划项目“大口径厚壁镍基合金直缝焊管JCO精密成形制备关键技术”。
关键词
JCOE
成型
模型
有限元
JCOE
forming
model
finite element method
