期刊文献+

多参数耦合下湿式换挡离合器滑摩特性

Slipping Friction Characteristics of Wet Shifting Clutch With Multi-Parameter Coupling
下载PDF
导出
摘要 以某车辆的湿式换挡离合器为研究对象,分析多参数耦合下湿式换挡离合器的滑摩特性.基于多体动力学和Hertz接触理论,在ADAMS软件中建立和验证离合器动态分析模型,仿真研究接合油压、摩擦副主、从动件初始转速差、摩擦因数,以及摩擦片刚度等因素对湿式换挡离合器滑摩特性的影响规律.结果表明:适当提高接合油压,增大摩擦因数、摩擦片刚度和摩擦副主、从动件初始转速差,可以有效改善湿式换挡离合器滑摩特性. Taking a vehicle′s wet shifting clutch as a research object,the slip characteristics of the wet shifting clutch under multi-parameter coupling were analysed.Based on multi-body dynamics and Hertz contact theory,a dynamic analysis model of the clutch was established and verified in ADAMS software.The influence oil pressure,friction sub-master,speed difference of follower,friction factor,and friction plate stiffness on the slip characteristics of wet shift clutch was studied through simulation.The results show that:properly improving the hydraulic pressure,increasing the friction factor,stiffness of friction plates and deputy chief of friction and initial rotation difference of follower can effectively improve the slip characteristics of the wet shift clutch.
作者 周宇航 李胜波 符升平 ZHOU Yuhang;Li Shengbo;FU Shengping(School of Mechanical and Automotive Engineering,Xiamen University of Technology,Xiamen 361024,China)
出处 《华侨大学学报(自然科学版)》 CAS 北大核心 2020年第5期568-574,共7页 Journal of Huaqiao University(Natural Science)
基金 国家自然科学基金资助项目(51975500) 福建省科技厅自然科学基金资助项目(2019J01862)。
关键词 湿式换挡离合器 多参数耦合 滑摩特性 动态分析 wet shifting clutch multi-parameter coupling slipping friction characteristics dynamic analysis
  • 相关文献

参考文献9

二级参考文献70

  • 1高晓敏,张协平,王晓明.离合器摩擦片非稳态温度场的计算[J].传动技术,1993(3):18-26. 被引量:3
  • 2杨树军,苑士华,胡纪滨.湿式离合器换挡过程动态特性[J].农业机械学报,2005,36(11):38-41. 被引量:30
  • 3张光裕,傅建业.动力换档变速箱的换档平稳性[J].工程机械,1990,21(1):27-31. 被引量:6
  • 4NATSUMEDA S, MIYOSHI T. Numerical Simulation of Engagement of Paper Based Wet Clutch Facing [J]. Journal of Tribology,1994,116(2):232-237.
  • 5BERGER E J, SADEGHI F, KROUSGRILL C M. Analytical and Numerical Modeling of Engagement of Rough, Permeable, Grooved Wet Clutches[J]. Journal of Tribology, 1997,119 (1) : 143-148.
  • 6GAO H, BARBER G C. Engagement of a Rough, Lubricated and Grooved Disk Clutch with a Porous Deformable Paper-based Friction Material[J]. Tribology Transactions, 2002,45 (4) : 464-470.
  • 7PATIR N, CHENG H S. Application of Average Flow Model to Lubrication Between Rough Sliding Surfaces [J]. Journal of Lubrication Technology, 1979,101 : 220-230.
  • 8GREENWOOD J A,TRIPP J H. The Contact of Two Nominally Flat Rough Surfaces[J].Proc Inst Mech Eng,1971,185:625-633.
  • 9Ma Biao,Proceeding of the IEEE International Vehicle Electronics Conference( IVEC’ 99#?999年,391页
  • 10马彪,博士学位论文,1999年

共引文献87

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部