摘要
射频放大器存在上电时序复杂且延时不精确,偏置点不易达到器件要求的问题。针对该问题,文中提出了一种基于STM32F302K8的射频放大器上电时序及偏置点控制的方法。通过单片机IO控制电源芯片上电,中断程序精确延时,保证射频放大器HMC637漏极电源和栅极电源按顺序上电。根据ADC采样偏置电流,采用DAC调节HMC637栅极电压,使得偏置电流达到要求值。测试结果表明,文中设计的方案可实现HMC637各电源按程序所设6 ms间隔顺序上电。调节栅极电压使偏置电流达到目标值400 mA,偏置流程完全符合器件要求。此外,该方案不受器件工艺等因素影响,具有自适应性,应用前景广阔。
The RF amplifier has the problems of complicated power-on sequence and inaccurate delay,and the bias point is not easy to meet the requirements of the device.To solve these problems,a method of controlling the power on timing sequence and bias point of RF amplifier based on STM32F302K8 is proposed in the present study.The method controlls the power chip to delay power-on by the microcomputer IO to ensure that the HMC637 drain power supply and the gate power supply are sequentially powered up.According to the ADC sampling bias current the DAC is used to adjust the HMC637 gate voltaget to make the bias current reach the required value.The test results show that the proposed method can realize the power-on sequence of each power supply at intervals of 6 ms,and adjust the gate voltage of HMC637 to make the bias current reach the target value of 400 mA,which fully meets the requirements of the chip.Additionally,the design is not affected by the device technology,and has self-adaptability and broad application prospect.
作者
何强
杨青慧
张怀武
HE Qiang;YANG Qinghui;ZHANG Huaiwu(State Key Laboratory of Electronic Thin Films and Integrated Devices,University of Electronic Science and Technology of China,Chengdu 610054,China)
出处
《电子科技》
2021年第2期1-6,共6页
Electronic Science and Technology
基金
国家自然科学基金(61021061,51272036,51472046,51002021,61131005)
国际合作基金(2012DFR10730,2013HH0003)。
