期刊文献+

锂离子电池异构建模及内部传质机理探究:粒径分布的影响 被引量:5

Heterogeneous modeling and internal mass transfer mechanism of lithium-ion batteries:effect of particle size distribution
下载PDF
导出
摘要 锂离子电池是目前应用较广的储能设备,具有能量密度高、使用寿命长等特点。随着锂离子电池正极材料实际能量密度接近理论值,电池组装工艺参数的优化成了提升其性能的重要途径,其中电极颗粒粒径及分布是十分重要的参数。因此,本文针对石墨-LiFePO4体系锂离子电池,利用异构模型构建单粒径和双粒径电极的几何结构,再结合Newman模型模拟其放电过程,定量研究了正极材料粒径分布对锂离子电池性能的影响,探究了存在粒径分布的电极中不同粒径的颗粒在充放电过程的作用机制。模拟结果表明,粒径的减小可以减小固相扩散系数对电池性能的影响,但会增加液相扩散阻力;而粒径的分布可以促进锂离子在电解液中的扩散,提高小粒径颗粒的锂嵌入量,但会引起极化增大,导致大颗粒的锂嵌入量降低。粒径分布宽度越大,总体粒度越大,锂离子电池的能量密度越小。选择合适的粒径分布宽度,适当减小总体粒度的大小,能有效提升电极的能量密度。研究结果对于锂离子电池电极活性材料颗粒粒径分布的选择提供了有益的基础知识和指导。 Lithium-ion batteries,as a kind of energy storage device with high energy density and long service life,have been widely applied in many fields.As the actual energy densities of cathode materials approach their theoretical values,the optimization of assembling parameters has become a crucial way to improve the performance of lithium-ion batteries.And the particle size distribution of the electrode particles is a very important parameter.In this work,heterogeneous models were used to construct geometry of electrode with single-sized particles and bimodal-sized LiFePO4(LFP)particles.Then the corresponding discharge processes of C-LFP system were quantitatively simulated by Newman model to investigate the impact of particle size distribution on the performance of lithium-ion batteries.The simulation results show that the reduction of the particle size reduced the influence of solid phase diffusion coefficient on battery performance,but increased the liquid phase diffusion resistance.Proper particle size distribution of active material could promote the diffusion of lithium ion in electrolyte and increase the lithium insertion amount inside the small particles,but cause heavier polarization,thus decreasing the lithium insertion amount inside the large particles.The wider distribution of the particles and the larger overall particle size,the smaller the energy density of the lithium ion battery.Choosing an appropriate active particle size with proper distribution can effectively enhance the energy density of lithium-ion batteries.The research results provide useful basic knowledge and guidance for the selection of particle size distribution of electrode active materials for lithiumion batteries.
作者 陈怡沁 许于 周静红 隋志军 周兴贵 CHEN Yiqin;XU Yu;ZHOU Jinghong;SUI Zhijun;ZHOU Xinggui(State Key Laboratory of Chemical Engineering,East China University of Science and Technology,Shanghai 200237,China)
出处 《化工学报》 EI CAS CSCD 北大核心 2021年第2期1078-1088,共11页 CIESC Journal
基金 国家自然科学基金项目(21676082) 国家重点基础研究发展计划项目(2014CB239702)。
关键词 锂离子电池 数学模拟 异构模型 粒径分布 lithium-ion battery mathematical modeling heterogeneous model particle size distribution
  • 相关文献

参考文献3

二级参考文献22

  • 1Padhi A K, Nanjundaswamy K S, Goodenough J B. Phospho-olivines as positive-electrode materials for rechargeable lithium batterise [J]. d Eleetroehem Soe, 1997, 4(144): 1188-1194.
  • 2Bandhauer T M, Garimella S, Fuller T F. A critical review of thermal issues in lithium-ion batteries [J]. J Eleetroehem Soe, 2011, 158(3): R1-R25.
  • 3Minato Egashira, AkinoriKanetomo, Nobuko Yoshimoto, et al. Charge-discharge rate of spinel lithium manganese oxide and olivine lithium iron phosphate in ionic liquid-based electrolytes [J]. Journal of Power Source, 2011,196(15): 6419-6424.
  • 4CHEN Wei-min, HUANG Yun-hui, YUAN Li-xia. Self-assembly LiFePO4/polyaniline composite cathode materials with inorganic acid as dopants for lithium-ion batteries [J]. Journal of Eleetroanalytical Chemistry, 2011,660(1): 108-113.
  • 5YIN Xiong-ge, HUANG Ke-long, LIU Su-qin, et al. Preparation and characterization of Na-doped LiFePO4 composites as cathode materials for lithium-ion batteries [J]. Journal of Power Source, 2010, 195(13): 4308-4312.
  • 6Julien C M, Mauger A, Zaghib K. Surface effects on electrochemical properties of nano-sized LiFePO4 [J]. Journal of Materials Chemistry, 2011, 21(27): 9955-9968.
  • 7Wang Qiang, Zhang Wei-xin, Yang Ze-heng, et al. Solvothermal synthesis of hierarchical LiFeP04 microflowers as cathode materials for lithium ion batteries [J]. Journal of Power Source, 2011,196(23): 10176-10182.
  • 8Asep Bayu Dani Nandiyanto, Kikuo Okuyama. Progress in developing spray-drying methods for the production of controlled morphology particles: From the nanometer submicrometer size ranges [J]. Advanced Powder Technology, 2011, 22( 1): 1-19.
  • 9Li Jian-lin, Claus Daniel, David Wood. Materilas processing for lithium-ion batteries [J]. Journal of Power Source, 2011, 196(5): 2452-2460.
  • 10Miran Gaberseck, Robert Dominko, Janez Jamnik. Is small particle size more important than carbon coating? An example study on LiFePO4 cathodes [J]. Electrochemistry Communications, 2007, 9(12): 2778-2783.

共引文献63

同被引文献21

引证文献5

二级引证文献10

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部