期刊文献+

基于元胞自动机的金属静态再结晶行为研究进展 被引量:3

Research progress of static recrystallization behavior of metals based on cellular automata
下载PDF
导出
摘要 静态再结晶是材料变形后通过热处理来改变组织状态的重要现象。本文重点综述总结了金属静态再结晶行为的数值模拟研究,首先简要介绍了计算材料科学中常用的元胞自动机(Cellular automata,CA)模拟方法,然后分别对元胞自动机模拟的动力学模型和物理模型发展进行详细综述,并分析总结了近年来元胞自动机在金属及其合金静态再结晶行为研究中的应用现状。最后,就金属静态再结晶行为的元胞自动机模拟研究提出相关建议。 Static recrystallization is an important way to change the microstructure of materials by heat treatment after deformation. This paper summarizes the numerical simulation of static recrystallization behavior of metals. Firstly, the simulation methods of cellular automata(Cellular automata,CA) commonly used in computational material science are briefly introduced, and then the dynamic and physical models development of cellular automata simulation are reviewed in detail. The application of cellular automata in the study of static recrystallization behavior of metals and their alloys in recent years is analyzed and summarized. Finally, some suggestions are put forward for the study of cellular automata simulation of static recrystallization behavior of metals.
作者 吕胡缘 胡励 时来鑫 周涛 杨明波 Lü Hu-yuan;HU Li;SHI Lai-xin;ZHOU Tao;YANG Ming-bo(School of Materials Science and Engineering,Chongqing University of Technology,Chongqing 400054,China;Chongqing Municipal Engineering Research Center of Institutions for Mould Technology,Chongqing University of Technology,Chongqing 400054,China)
出处 《材料热处理学报》 EI CAS CSCD 北大核心 2021年第2期1-10,共10页 Transactions of Materials and Heat Treatment
基金 国家自然科学基金(51805064,51701034,51822509) 重庆市教委科学技术研究项目(KJQN201801137KJ1600922) 重庆市基础研究与前沿探索项目(cstc2017jcyjAX0062,cstc2018jcyjAX0035,cstc2017jcyjAX0381)。
关键词 静态再结晶行为 微观组织模拟 元胞自动机法 再结晶模型 static recrystallization behavior microstructure simulation cellular automata recrystallization model
  • 相关文献

参考文献5

二级参考文献47

  • 1郑成武,兰勇军,肖纳敏,李殿中,李依依.热变形低碳钢中奥氏体静态再结晶介观尺度模拟[J].金属学报,2006,42(5):474-480. 被引量:16
  • 2王智平,肖荣振,朱昌盛,徐建林,王延露.Ni-Cu二元合金定向凝固的相场法数值模拟[J].稀有金属材料与工程,2006,35(A02):369-373. 被引量:10
  • 3石伟,范洪涛,刘庄.Cr5支承辊用钢马氏体相变的相变塑性研究[J].材料热处理学报,2006,27(5):122-125. 被引量:16
  • 4申孝民,关小军,张继祥,刘运腾,麻晓飞,赵宪明.有限元与Monte Carlo方法耦合的冷轧纯铝板再结晶模拟[J].中国有色金属学报,2007,17(1):124-130. 被引量:14
  • 5Ivasishin O M, Shevchenko S V, Vasiliev N L, et al. A 3-D Monte-Carlo (Potts) model for recrystallization and grain growth in polycrystalline materials [J]. Materials Science and Engineering A ,2006,433 ( 1 - 2) :216 - 232.
  • 6Rollett A D, Raabe D. A hybrid model for mesoscopic simulation of recrystallization[ J]. Computational Materials Science ,2001,21 (1) :69 -78.
  • 7Marx V,Reher F R, Gottstein G. Simulation of primary recrystallization using a modified three-dimensional cellular automaton [J]. Acta Materialia, 1999,47 (4) : 1219 - 1230.
  • 8Goetz R L, Seetharaman V. Static recrystallization kinetics with homogeneous and heterogeneous nucleation using a cellular automata model [ J ]. Metallurgical and Materials Transactions A, 1998,29 (9) :2307 - 2321.
  • 9Sttiwe H P, Padilha A F, Siciliano F. Competition between recovery and recrystallization [ J ]. Materials Science and Engineering A ,2002,333 ( 1 - 2 ) : 361 - 367.
  • 10Song X Y, Rettenmayr M. Modeling study on recrystallization, recovery and their temperature dependence in inhomogeneously deformed materials [ J ]. Materials Science and Engineering A ,2002,332 ( 1 - 2 ) : 153 - 160.

共引文献14

同被引文献38

引证文献3

二级引证文献10

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部