摘要
Topology optimization is an effective method to obtain a lightweight structure that meets the requirements of structural strength.Whether the optimization results meet the actual needs mainly depends on the accuracy of the material properties and the boundary conditions,especially for a tiny Flapping-wing Micro Aerial Vehicle(FMAV)transmission system manufactured by 3D printing.In this paper,experimental and numerical computation efforts were undertaken to gain a reliable topology optimization method for the bottom of the transmission system.First,the constitutive behavior of the ultraviolet(UV)curable resin used in fabrication was evaluated.Second,a numerical computation model describing further verified via experiments.Topology optimization modeling considering nonlinear factors,e.g.contact,friction and collision,was presented,and the optimization results were verified by both dynamic simulation and experiments.Finally,detailed discussions on different load cases and constraints were presented to clarify their effect on the optimization.Our methods and results presented in this paper may shed light on the lightweight design of a FMAV.
基金
supported by the National Natural Science Foundation of China(No.11672022)。