振荡回路元件参数分析与计算

Parameter Analysis and Calculation of Oscillation Circuit Element

本文介绍了大容量试验室振荡回路的试验参数计算方法,并在此基础上利用Atp软件模拟了试验成功和试验失败工况下振荡回路各元件承受的耐受电压、耐受电流和热容量,最后以电容器组和电阻器组为例,给出了振荡回路元件参数的确定步骤。分析结果表明,本文所提方法对大容量实验室振荡回路元件参数的确定具有一定的适用性。

The calculation method of the test parameters of the oscillation circuit in the high power laboratory is introduced in this paper.On this basis,the Atp software was used to simulate the withstand voltage,the withstand current and the heat capacity of each element in the oscillation circuit under the conditions of successful and failed tests.Finally,the capacitor and the resistor banks are taken as examples to show the steps to determine the parameters of the oscillator circuit.The analysis results show that the method proposed in this paper has certain applicability to the determination of the parameters of the oscillation circuit elements in the high power laboratory.