期刊文献+

四甲基硅烷和苯等离子体沉积促进树脂与牙科氧化锆陶瓷粘接的即刻粘接效果实验研究 被引量:1

Experimental Study on the Immediate Bonding Effect of Resin to Dental Zirconia Ceramics by Plasma Deposition of Tetramethyl Silane and Benzene
下载PDF
导出
摘要 目的:探究四甲基硅烷(TMS)与苯等离子体连续沉积对树脂与牙科氧化锆陶瓷粘接的粘接强度的影响。方法:将55个氧化锆陶瓷片随机分为TMS组、苯等离子体组、TMS^(+)苯等离子体组、氧化锆涂底剂(ZPP)组及对照组,每组11个氧化锆陶瓷片。按照分组给予不同的氧化锆表面处理,采用X射线光电子能谱分析仪观察各组表面化学元素含量及种类,采用透射电子显微镜观察TMS^(+)苯等离子体组表面涂层结构,采用剪切粘接强度试验观察给予不同表面处理后各组粘接强度及断裂模式。结果:TMS组、苯等离子体组、TMS^(+)苯等离子体组、ZPP组碳原子含量及碳氧比均低于对照组(P<0.05)。透射电镜图像显示TMS^(+)苯等离子体组经过TMS与苯的连续等离子体沉积后,在二氧化锆(ZrO_(2))层上观察到有明显的两个紧密结合涂层。TMS组、苯等离子体组、TMS^(+)苯等离子体组、ZPP组粘接强度均高于对照组(P<0.05);TMS^(+)苯等离子体组粘接强度均高于TMS组、苯等离子体组、ZPP组(P<0.05)。各组均无内聚断裂,混合断裂占比最高的为TMS^(+)苯等离子体组,为100.00%。结论:采用TMS与苯等离子体连续沉积可明显提高复合树脂与氧化锆陶瓷之间的粘接强度。 Objective To investigate the effect of plasma deposition of tetramethylsilane(TMS)and benzene on resin bonding to dental zirconia ceramic.Methods A total of 55 zirconia specimens were randomly divided into five groups for different treatments,TMS group,benzene plasma deposition group,TMS^(+)benzene plasma deposition group,zirconia primer plus(ZPP)group and control group,each with 11 specimens.The surface chemical compositions were characterized via X-ray photoelectron spectroscopy.The surface coating structure of TMS^(+)benzene plasma group was observed by transmission electron microscope.Shear bond-strength test was used to observe the bonding strength and fracture mode of each group after different treatments.Results The carbon atom content and carbon-oxygen ratio of TMS group,benzene plasma deposition group,TMS^(+)benzene plasma deposition group and ZPP group were lower than those in control group(P<0.05).X-ray spectroscopy showed that two layers on ZrO_(2) were formed through sequential deposition with TMS and benzene.The bond strength of TMS group,benzene plasma deposition group,TMS^(+)benzene plasma deposition group and ZPP group was significantly higher than that in control group(P<0.05).The bond strength of TMS^(+)benzene plasma deposition group was significantly higher than that in TMS group,benzene plasma deposition group and ZPP group(P<0.05).There were no cohesive fractures in each group,and the highest proportion of mixed fractures was 100.00%in the TMS^(+)benzene plasma deposition group.Conclusion Application of plasma deposition of TMS and benzene can significantly promote the resin bonding to dental zirconia ceramic.
作者 毛然然 邱丽芳 MAO Ran-ran;QIU Li-fang(Department of Stomatology,Affiliated Stomatological Hospital of Nanjing Medical University(Jiangsu Provincial Stomatological Hospital),Nanjing 210000,Jiangsu,China)
出处 《中国美容医学》 CAS 2021年第3期113-116,共4页 Chinese Journal of Aesthetic Medicine
关键词 四甲基硅烷 等离子体 复合树脂 氧化锆陶瓷 粘接强度 tetramethylsilane benzene plasma deposition composite resin zirconia ceramic bond strength
  • 相关文献

参考文献11

二级参考文献78

  • 1许丕池,余海湖,何方方,卢忠远,康明.热处理温度对静电自组装PDDA/SiO_2光学薄膜的影响[J].武汉理工大学学报,2005,27(1):10-13. 被引量:2
  • 2Ban S, Sato H, Suehiro Y, et al. Biaxial flexure strength and low temperature degradation of Ce- TZP/A1203 nanocomposite and Y-TZP as dental re- storatives[J]. J Biomed Mater Res B Appl Biomater, 2008, 87(2):492-498.
  • 3Pittavachawan P, McDonald A, Young A, et al. Flexural strength, fatigue life, and stress-induced phase transformation study of Y-TZP dental ceramic [J]. J Biomed Mater Res B Appl Biomater, 2009, 88 (2):366-377.
  • 4Christel P, Meunier A, Heller M, et al. Mechanical properties and short-term in vivo evaluation of yttrium-oxide-partially-stabilized zirconia[J]. J Biomd Mater Res, 1989, 23(1):46-61.
  • 5Cattani-Lorente M, Scherrer SS, Ammann P, et al. Low temperature degradation of a Y-TZP dental ceramic[J]. Acta Biomater, 2011, 7(2):858-865.
  • 6Shah K, Holloway JA, Denry IL. Effect of coloring with various metal oxides on the microstructure, color, and flexural strength of 3Y-TZP[J]. J Biomed Mater Res B Appl Biomater, 2008, 87(2):329-337.
  • 7Guazzato M, Proos K, Quach L, et al. Strength, reliability and mode of fracture of bilayered porcelain/zirconia (Y-TZP) dental ceramics[J]. Biomaterials, 2004, 25 (20):5045-5052.
  • 8Blatz MB, Sadan A, Martin J, et al. In vitro evaluation of shear bond strengths of resin to densely-sintered high-purity zirconium-oxide ceramic after long-term storage and thermal cycling[J]. J Prosthet Dent, 2004, 91(4):356-362.
  • 9Kern M, Wegner SM. Bonding to zirconia ceramic: adhesion methods and their durability[J]. Dent Mater, 1998, 14(1):64-71.
  • 10Wolfart M, Lehmann F, Wolfart S, et al. Durability of the resin bond strength to zirconia ceramic after using different surface conditioning methods[J]. Dent Mater, 2007, 23(1):45-50.

共引文献85

同被引文献2

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部