期刊文献+

绞吸船在软土地质下横移锚抓地力计算方法 被引量:2

Calculation method of sideway anchor grasping force of cutter suction dredger in soft soil
下载PDF
导出
摘要 大型绞吸船采用三角宽鳍锚作为横移挖掘的定位锚,针对横移锚在软土地质条件下锚抓力受限的问题,采用土体的极限平衡原理进行横移锚受力分析,建立三角宽鳍横移锚抓地力计算方法。经计算分析,在软土地质条件下,影响横移锚抓地力的主要因素为锚冠入土深度、土楔破坏角和锚杆角度。结果表明,锚冠入土越深,锚抓地力越大;锚杆与水平面夹角越小,锚抓地力越大;随土楔破坏角逐步增加,锚抓地力呈先减小、后变大的趋势;土楔破坏角在20°~25°时,横移锚抓地力最小,锚抓力系数为14左右。 The cutter suction dredger uses a triangle broad fin anchor as the positioning anchor for sideway dredging. Aiming at the problem that the grasping force of the sideway anchor is limited under the soft soil,we carry out the force analysis of the sideway anchor by using the limit equilibrium principle of soil and establish the calculation method of the grasping force of the sideway anchor. Based on the calculation,the main factors affecting the grasping force of sideway anchor are the depth of anchor crown into the soil,the failure angle of soil wedge,and the angle of anchor rod. The results show that the deeper the anchor crown goes into the soil,the greater the anchor grasping force. The smaller the angle between the anchor rod and the horizontal plane,the greater the anchor grasping force. With the gradual increase of the failure angle of the soil wedge,the anchor grasping force first decreases and then increases. When the soil wedge failure angle is between 20° and 25°,the anchor grasping force is the smallest,and the anchor grasping force coefficient is about 14.
作者 李晟 郑剑飞 LI Sheng;ZHENG Jian-Fei(CCCC Shanghai Dredging Co.,Ltd.,Shanghai 200002,China)
出处 《水运工程》 北大核心 2021年第4期15-19,29,共6页 Port & Waterway Engineering
关键词 大型绞吸船 软土地质 横移锚 锚抓力 large cutter suction dredger soft soil sideway anchor anchor grasping force
  • 引文网络
  • 相关文献

参考文献2

二级参考文献16

  • 1李宇服,周俊,陈琦.钦州港锚地规划及锚抓力研究[J].中国水运(下半月),2009,9(9):11-13. 被引量:10
  • 2中村技研工紫有限会社.会社概要[EB/OL].http://www1.ttcn.ne.jp/-vulcan-anchor/company.html.
  • 3日本社会贡献支援财团.受赏者绍介[EB/OL].http://www.fesco.or.jp/winner/hi7/314.php.
  • 4HINATA H,MICHIMOTO J,KAWAMURA Y,et al. Experimental studies on the holding power of anchors[C]//Proc 17th Int Offshore & Polar Eng Conf,2007: 1347-1352.
  • 5SHOJI K,MINAMI K,MITA S,et al. Holding performance of a new type anchor[C]//Proc Asia Navigation Conf,2008: 108-114.
  • 6佐藤治夫.錨の把駐性能に関する一考察[J].J School Mar Sci & Technol,2005 ,3(3):31-39.
  • 7中村技研工業有限会社.高性能アンカーDA-1型の性能試験について[EB/OL].http://www1.ttcn.ne.jp/-vulcan-anchor/DataFile/DA-1info. pdf.
  • 8佐藤治夫,河内尚,野隊朋樹.大型船用錨の把駐性能に関する一考察[J].J School Mar Sci & Technol,2009,7(2): 41-47.
  • 9SH1N H K, SEO B C, LEE J H. Experimental study of embedding motion and holding power of drag embedment type anchor on hard and soft seafloor[J]. International Journal of Naval Architect and Ocean Engineering, 2011, 3: 193-200.
  • 10LELIEVRE B, TABATABAEE J. The performance of marine anchors with planar flukes in sand[J] .Canadian Geoteehnieal Journal,1981 (18): 520-534.

共引文献12

同被引文献3

引证文献2

;
使用帮助 返回顶部