摘要
根据道路照明相关国家标准及国际标准,结合工厂道路的实际工况,探讨工业项目中道路照明各项评价指标的选取,认为均匀度、纵向均匀度、环境比以及眩光宜根据CIE标准来确定,路面平均亮度和路面平均照度的标准值确定可参考国家标准;然后结合实际工程经验,采用DIALUX软件进行模拟计算,针对实际设计中道路照明光源、灯具的选取以及灯具的布置方式等问题提出相关建议。
According to the relevant national standards and international standards of roads lighting,and combined with the actual working condition of factory road,this article studied and analyzed the selection of evaluation indicators of road lighting in industrial projects.The uniformity,longitudinal uniformity,surround ratio and dazzle should be determined according to the CIE standard.The standard values of the average brightness and average illuminance of the pavement can be determined according to the national standards.Then,combined with practical engineering experience,DIALUX software was used for simulation calculation,the selection of road lighting lamps,light sources and lamp layout in the actual design were proposed.
出处
《有色冶金节能》
2021年第2期33-38,共6页
Energy Saving of Nonferrous Metallurgy
关键词
工业建筑
道路照明
照度
亮度
均匀度
环境比
炫光
灯具布置
设计
industrial building
road lighting
illuminance
brightness
uniformity
surround ratio
lamp layout
design
