摘要
基于FLOW-3D CAST软件,分别对压铸模在空气冷却、喷涂冷却、水道冷却条件下进行模拟,分析3种冷却方式对模温的影响,并且与实际测量模温对比。最后对比分析FLOW-3D CAST软件采用喷涂工艺模块模拟与传统喷涂模拟结果,发现喷涂冷却能够更准确模拟模具温度。
The natural air cooling,spraying cooling and water channel cooling of die casting die were simulated by FLOW-3 D CAST software.The effects of cooling methods on the temperature of die casting die were analyzed,which compared with the actual measurement of mold temperature verification.Finally,the simulation results of FLOW-3 D CAST using spraying process module were compared with traditional spraying simulation.It is concluded that spray cooling can more accurately simulate die casting die temperature.
作者
刘绪周
王斌
Liu Xuzhou;Wang Bin(HASCO KSPG Nonferrous Components(Shanghai)Co.,Ltd.;PSB Engineering(Suzhou)Co.,Ltd.)
出处
《特种铸造及有色合金》
CAS
北大核心
2021年第5期641-643,共3页
Special Casting & Nonferrous Alloys
关键词
数值模拟
模具表面温度
模温控制
模具冷却
空冷
水冷
喷涂工艺
Numerical Simulation
Die Surface Temperature
Die Temperance Control
Die Cooling
Air Cooling
Water Cooling
Spray Cooling
