基于STC89C52的高空智能防摔花盆设计

Design of high altitude intelligent anti falling flowerpot based on STC89C52

本文采用51单片机作为高空智能防摔花盆控制器的控制核心,结合MPU6050加速度传感器模块、单片机控制模块、报警器模块和舵机动作模块,完成了高空智能防摔花盆的软硬件设计。加速度信号的采集、存储和处理通过MPU6050加速度传感器模块实现,检测到范围内加速度波动之后,舵机动作模块进行动作花盆降落伞打开,并发出声光报警。本设计用于高层养花,可避免高层阳台上的花盆坠落所造成的砸伤路人的恶劣现象。

In this paper,51 single-chip microcomputer is used as the control core of high-altitude intelligent anti falling flowerpot controller.Combined with mpu6050 acceleration sensor module,single-chip microcomputer control module,alarm module and steering gear action module,the software and hardware design of high-altitude intelligent anti falling flowerpot is completed.The acceleration signal is collected,stored and processed by mpu6050 acceleration sensor module.After the acceleration fluctuation is detected in the range,the actuator action module acts,the flowerpot parachute is opened,and the sound and light alarm is sent out.The design is used for high-rise flower cultivation,which can avoid the bad phenomenon of hurting passers-by caused by the flower pot falling on the high-rise balcony.