摘要
为了测试在大拉力载荷下,海底电缆张力弯曲试验装置是否能正常工作,利用有限元分析方法对鼓轮与海缆进行了建模与仿真,并对整个有限元模型进行了应力、应变和位移分析。结果表明,该张力弯曲试验装置在2×106 N的拉力载荷下,应力最大值达到1.05×108 Pa,并未超过碳钢的屈服强度,没有发生大变形,能够正常工作,装置设计方案合理。
In order to test whether the submarine cable tension bending test device can work normally under high tensile load,the finite element analysis method was used to model and simulate the drum and the submarine cable,and finishing the stress,strain and displacement analysis.The results show that under the tensile load of 2×106 N,the maximum stress reaches 1.05×108 Pa,which does not exceed the yield strength of carbon steel.The overlarge deformation does not occur,and the test device can work normally,which means the design scheme of the submarine cable tension bending test device is reasonable.
作者
乐彦杰
郑新龙
黄崇武
吕安强
卢正通
敬强
LE Yanjie;ZHENG Xinlong;HUANG Chongwu;LYU Anqiang;LU Zhengtong;JING Qiang(Zhoushan Power Supply Company of State Grid Zhejiang Electric Power Company,Zhoushan 316021,Zhejiang,China;Zhejiang Zhoushan Marine Power Research Institute Co.,Ltd.,Zhoushan 316021,Zhejiang,China;Department of Electronic and Communication Engineering,North China Electric Power University,Baoding 071003,Hebei,China)
出处
《机械科学与技术》
CSCD
北大核心
2021年第9期1385-1390,共6页
Mechanical Science and Technology for Aerospace Engineering
基金
国家重点研发计划项目(2016YFB0900705)
国家电网有限公司科技项目(5211011600LF)。
关键词
张力弯曲试验装置
海底电缆
有限元分析
应力
应变
tension bending test device
submarine cable
finite element analysis
stress
strain
