挂板成形工艺分析与模具设计

Stamping process analysis of hanging plate and the die design

介绍电热水器挂板的成形工艺及模具结构设计,针对壁厚为3 mm制件的成形,为了加强模具零件强度及延长模具的使用寿命,采用一系列的方法对模具结构进行改进。模具经生产实践验证:成形的制件符合设计要求,对于壁厚较厚的制件成形具有一定的借鉴作用。

The forming process and die structure design of electric water heater hanging plate were introduced.Aiming at the forming of parts with wall thickness of 3 mm,a series of methods were adopted to strengthen the strength of die parts and prolong the service life of die.The production practice proved that the forming parts met the design requirements,and it could be used as a refer⁃ence for the forming parts with thick wall.