摘要
本文通过对一数据中心空气冷却器的结构及性能参数的分析,在保持冷热流体进口条件不变的前提下,从增大换热面积,提升换热系数两个方面提出了针对该换热器的两种基本改进方案。其中方案二通道高度为6mm的情形可在相同泵功的条件下,提升换热量9%,且仅要求对原换热器芯片间的距离进行调整,对原冷却系统的整体结构并无影响。
In this paper,the heat transfer performance of an air-cooling unit used for data center cooling is analyzed.Under the condition of remaining the same inlet conditions as the original one,this paper proposes two basic improvement schemes.Scheme 2 can increase the heat transfer rate by 9%with the same pump power.This scheme only demands the adjustment of the distance between the heat exchange plates without any effect on the overall structure of the original cooling system.
作者
王子星
雷乐
李楠
陶文铨
WANG Zi-Xing;LEI Le;LI Nan;TAO Wen-Quan(Key Laboratory of Thermal Fluid Science and Engineering of MOE,School of Energy and Power Engineering,Xi’an Jiao tong University,Xi’an Shaanxi,710049,China)
出处
《工程热物理学报》
EI
CAS
CSCD
北大核心
2021年第12期3249-3253,共5页
Journal of Engineering Thermophysics
基金
国家自然科学基金创新群体资助项目(No.51721004)
西安市科技局的资助项目(No.20192187.No.14SYS002CG024)。
关键词
数据中心
空气冷却器
数值仿真
data center
air cooling unit
numerical simulation