摘要
采用扫描电镜(SEM)、能谱仪(EDS)、电化学工作站、中性盐雾试验等手段研究了3种不同冷却速度(5℃/s、10℃/s和20℃/s)对锌铝镁镀层组织及耐蚀性能的影响。结果表明:热浸镀获得锌铝镁镀层截面组织由块状富Zn相、Zn-MgZn2二元共晶相和细小的Zn-MgZn2-Al三元共晶相组成;随着冷速的提升,锌铝镁镀层表面富锌相的晶粒尺寸逐步减小;冷速10℃/s下获得的锌铝镁镀层断面中的富锌相尺寸较小;冷速10℃/s下获得的锌铝镁镀层的耐蚀性较好。
The effects of three different cooling rates(5℃/s,10℃/s and 20℃/s)on the microstructure and corrosion resistance of Zn-Al-Mg coating were studied by means of scanning electron microscope(SEM),energy dispersive spectroscopy(EDS),electrochemical workstation and neutral salt spray test.The results show that the cross-section structure of zinc aluminum magnesium coating obtained by hot-dip plating is composed of massive Zn rich phase,Zn-MgZn2 binary eutectic phase and fine Zn-MgZn2-Al ternary eutectic phase.With the increasing of cooling rate,the grain size of zinc rich phase on the surface of Zn-Al-Mg coating decreases gradually.The size of zinc rich phase in the section of Zn-Al-Mg coating obtained at cooling rate of 10℃/s is small,and the zinc aluminum magnesium coating obtained at cooling rate of 10℃/s has good corrosion resistance.
作者
张鹏
张杰
梁爱国
梅淑文
孙力
张启富
于程福
Zhang Peng;Zhang Jie;Liang Aiguo;Mei Shuwen;Sun Li;Zhang Qifu;Yu Chengfu(National Engineering Laboratory of Advanced Metal Material Coating, Central Iron & Steel Research Institute, Beijing 100081;HBIS Group Research Institute, Shijiazhuang 050023, Hebei;HBIS Group Tangsteel Company, Tangshan 063000, Hebei)
出处
《河北冶金》
2022年第1期30-33,共4页
Hebei Metallurgy
关键词
冷却速度
锌铝镁镀层
组织
耐蚀性能
富锌相
晶粒尺寸
cooling rate
zinc-aluminum-magnesium coating
organization
corrosion resistance
zinc rich phase
grain size
