摘要
针对传统的测量技术在零件尺寸测量方面效率低、精确度不高的问题,设计一种以S7-1200PLC为控制器并与机器视觉相结合的零件测量系统。该系统由机械执行、电气控制、图像处理、上位机软件四部分组成,形成了集零件传送、测量、剔除、回收的一体化智能测量系统模型。最后对实际零件进行检测实验,结果表明该系统运行稳定、测量误差小、效率高,系统抗干扰能力强。
Aiming at the problem of low efficiency and low accuracy of traditional measurement technology in part size measurement,a part measurement system with S7-1200PLC as the controller and combined with machine vision was designed.The system consists of four parts:mechanical execution,electrical control,image processing,and host computer software,forming an intelligent measurement system model that integrates parts transmission,measurement,rejection,and recycling.Finally,the actual parts were tested and the results showed that the system runs stably,with small measurement errors,high efficiency and strong anti-interference ability.
作者
刘团结
胡艳丽
贾群
殷杰
LIU Tuan-jie;HU Yan-li;JIA Qun;YIN Jie(School of Mechanical and Electrical Engineering,Huainan Normal University,Huainan,232038,Anhui)
出处
《蚌埠学院学报》
2022年第2期46-50,共5页
Journal of Bengbu University
基金
安徽省优秀拔尖人才培养资助项目(gxyq2020047)。
关键词
零件测量
机器视觉
系统设计
图像处理
上位机
可编程控制器
parts measurement
machine vision
system design
image processing
host computer
programmable controller
