Induced current of high temperature superconducting loops by combination of exciting coil and thermal switch

With its commercialization, the second-generation(2G) high temperature superconducting(HTS) RE–Ba–Cu–O(REBCO, RE is rare earth) tape is extensively applied to the superconducting magnets in the high magnetic fields. However,unlike low temperature superconducting(LTS) magnets, the HTS magnet cannot operate in the persistent current mode(PCM) due to the immature superconducting soldering technique. In this paper, an exciting method for two HTS sub-loops,so-called charging and load loops, is proposed by flux pump consisting of exciting coil and controllable thermal switch.Two HTS sub-loops are made of an REBCO tape with two slits. An exciting coil with iron core is located in one sub-loop and is supplied with a triangular waveform current so that magnetic field is generated in another sub-loop. The influence of magnetic flux on induced current in load loop is presented and verified in experiment at 77 K. The relationship between the induced magnetic flux density and the current on the sub-loops having been calibrated, magnetic flux density, and induced current are obtained. The results show that the HTS sub-loops can be excited by a coil with thermal switch and the induced current increases with magnetic flux of exciting coil increasing, which is promising for persistent current operation mode of HTS magnets.