摘要
In this work,we present a fully atomistic approach to modeling a finishing process with the goal to shed light on aspects of work piece development on the microscopic scale,which are difficult or even impossible to observe in experiments,but highly relevant for the resulting material behavior.In a large-scale simulative parametric study,we varied four of the most relevant grinding parameters:The work piece material,the abrasive shape,the temperature,and the infeed depth.In order to validate our model,we compared the normalized surface roughness,the power spectral densities,the steady-state contact stresses,and the microstructure with proportionally scaled macroscopic experimental results.Although the grain sizes vary by a factor of more than 1,000 between experiment and simulation,the characteristic process parameters were reasonably reproduced,to some extent even allowing predictions of surface quality degradation due to tool wear.Using the experimentally validated model,we studied time-resolved stress profiles within the ferrite/steel work piece as well as maps of the microstructural changes occurring in the near-surface regions.We found that blunt abrasives combined with elevated temperatures have the greatest and most complex impact on near-surface microstructure and stresses,as multiple processes are in mutual competition here.
出处
《Friction》
SCIE
EI
CAS
CSCD
2022年第4期608-629,共22页
摩擦(英文版)
基金
This work was funded by the Austrian Research Promotion Agency FFG(Project SyFi,No.864790)
Part of this work was funded by the Austrian COMETProgram(Project K2 InTribology1,No.872176)
carried out at the“Excellence Centre of Tribology”.The computational results presented have been achieved using the Vienna Scientific Cluster(VSC)
The government of Lower Austria is gratefully acknowledged for financially supporting the endowed professorship tribology at the Vienna University of Technology(Grant No.WST3-F-5031370/001-2017)in collaboration with AC2T research GmbH.The authors wish to thank Katharina Newrkla and Ulrike Cihak-Bayr for performing topography measurements of the experimental work pieces and providing pre-processed data for the PSD evaluations.