An analysis of the uniformity of multi-fracture initiation based on downhole video imaging technology: A case study of Mahu tight conglomerate in Junggar Basin, NW China

To solve the problem that the production of Mahu conglomerate reservoir is not up to expectation after the multi-cluster plus temporary plugging fracturing technology is applied in horizontal wells, stages 2–6 in the test well MaHW6285 are selected to carry out erosion tests with different pumping parameters. The downhole video imaging technology is used to monitor the degree of perforations erosion, and then the fracture initiation and proppant distribution of each cluster are analyzed. The results showed that proppant entered 76.7% of the perforations. The proppant was mainly distributed in a few perforation clusters, and the amount of proppant entered in most of the clusters was limited. The proppant distribution in Stage 4 was relatively uniform, and the fracture initiation of each cluster in the stage is more uniform. The proppant distribution in stages 2, 3, 5, and 6 was significantly uneven, and the uniform degree of fracture initiation in each cluster is low. More than 70% of the proppant dose in the stage entered clusters near the heel end, so the addition of diverters did not promote the uniform initiation of hydraulic fractures. There was a positive correlation between the amount of proppant added and the degree of perforations erosion, and the degree of perforations erosion ranged from 15% to 352%, with an average value of 74.5%, which was far higher than the statistical results of shale reservoir tests in North America. The use of 180° phase perforation(horizontal direction) can reduce the “Phase Bias” of perforations erosion, promote uniform perforations erosion and fluid inflow. The research results provide the basis for optimizing the pumping procedure, reducing the perforation erosion and improving the success rate of diversion.