期刊文献+

Gas-liquid mass transfer in the gas-liquid-solid mini fluidized beds 被引量:1

原文传递
导出
摘要 The gas-liquid-solid mini fluidized bed(GLSMFB)combines the advantages of fluidized bed and micro-reactor,and meets the requirements for safety and efficiency of green development of process industry.However,there are few studies on its flow performance and no studies on its mass and heat transfer performance.In this paper,the characteristics of gas-liquid mass transfer in a GLSMFB were studied in order to provide basic guidance for the study of GLSMFB reaction performance and application.Using CO_(2)absorption by NaOH as the model process,the gas-liquid mass transfer performance of GLSMFB was investigated.The results show that the liquid volumetric mass transfer coefficient and the gas-liquid interfacial area both increase with the increase of the superficial gas velocity within the experimental parameter range under the same given superficial liquid velocity.At the same ratio of superficial gas to liquid velocity,the liquid volumetric mass transfer coefficient increases with the increase of the super-ficial liquid velocity.Fluidized solid particles strengthen the liquid mass transfer process,and the liquid volumetric mass transfer coefficient is about 13%higher than that of gas-liquid mini bubble column.
出处 《Particuology》 SCIE EI CAS CSCD 2022年第10期22-30,共9页 颗粒学报(英文版)
基金 the National Natural Science Foundation of China(grant No.22178256).
  • 相关文献

参考文献6

二级参考文献50

  • 1刘燕,张廷安,赵洪亮,王淑婵,豆志河,蒋孝丽,赫冀成.CO_2微细气泡在NaOH溶液中吸收速率研究[J].过程工程学报,2009,9(S1):185-188. 被引量:6
  • 2P. Snabre,F. Magnifotcham.I. Formation and rise of a bubble stream in a viscous liquid[J]. The European Physical Journal B . 1998 (3)
  • 3Liu Yan,Sano Masamichi,Zhang TingAn,et al.Intensification of Bubble Disintegration and Dispersion by Mechanical Stirring in Gas Injection Refining. ISIJ International . 2009
  • 4Liu Yan,Masamichi Sano,Wang Qiang,et al.Physical Simulation on Desulfurization by Single Blow Grain Mg. Journal of Northeastern University(S) . 2006
  • 5Kumar,N R kuloor.The formation of bubble and drops. Cbm Eng Sci . 1969
  • 6Miyahara,M Tanimoto,T Takahashi.Bubble formation from an orifice at high gas injection rates the size of bubbles above an orifice. Kagaku Kogaku Ronbunshu . 1982
  • 7Liu Yan,Zhang Ting’’an,Masamichi Sano,et al.:Bubble disintegration and dispersion by eccentric mechanical stirring in gas injection refining for iron and steel making. The Third Baosteel Academic Conference . 2008
  • 8Liu Yan,Masamichi Sano,Wang Qiang,et al.Mechanical Stirring for Gas Injection Refining in Iron and Steel Making-1-Intensification of Bubble Disintegration. ISIJ Meeting . 2007
  • 9Liu Yan,Masamichi Sano,Wang Qiang,et al.Mechanical Stirring for Gas Injection Refining in Iron and Steel Making-2–Enhancement of Absorption of Injected Gas. ISIJ Meeting . 2007
  • 10Liu Yan,Masamichi Sano,Wang Qiang,et al.Mechanical Stirring for Gas Injection Refining in Iron and Steel Making-3-Eccentric Mechanical Stirring for Bubble Disintegration. ISIJ Meeting . 2008

共引文献13

同被引文献4

引证文献1

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部