摘要
从热力学角度对CO_(2)用于不锈钢冶炼可行性进行了分析,通过热力学计算研究,发现在C含量不低于0.25%时,将CO_(2)用于不锈钢冶炼是可行的。建立了喷吹CO_(2)冶炼410S不锈钢工艺模型,该模型能够较好拟合实际应用CO_(2)冶炼过程。并通过70 t TSR炉工业试验结果进行验证。试验结果表明:CO_(2)用于不锈钢冶炼具有强化脱碳及减少铬烧损的效果,与原工艺相比,同期C含量降低0.011%,Cr含量提高0.144%。
The feasibility of CO_(2) used in stainless steel smelting is analyzed from the view of thermodynamics.It is found that CO_(2) used in stainless steel smelting is feasible when the C content is not less than 0.25%.A material and energy model for 410 S stainless steel smelting by CO_(2) injection is established.The model can fit the practical CO_(2) smelting process well.The test results of 70 t TSR furnace in TaiShan stainless steel plant show that CO_(2) used in stainless steel smelting has the effect of decarburization and chromium preservation.Compared with the original process,the content of C decreases by 0.011%and the content of Cr increases by 0.144%.
作者
薛志涛
朱荣
周赟
董凯
魏光升
XUE Zhitao;ZHU Rong;ZHOU Yun;DONG Kai;WEI Guangsheng(School of Metallurgical and Ecological Engineering,University of Science and Technology Beijing,Beijing 100083,China;Beijing Key Laboratory of Special Melting and Preparation of High-end Metal Materials,Beijing 100083,China)
出处
《工业加热》
CAS
2022年第10期22-26,共5页
Industrial Heating
基金
山东省重大科技创新工程项目(2019JZZY010358)。
关键词
脱碳保铬
不锈钢冶炼
CO_(2)
工艺模型
工业试验
decarburization and chromium preservation
stainless steel smelting
CO_(2)
process model
industrial test
