Microstructures,Thermal and Mechanical Properties of Pure Tungsten—A Comparison Between Selective Laser Melting and Hot Rolling

A comparative study on the influence of different manufacturing methods(selective laser melting and hot rolling)on the microstructure,mechanical and thermal behaviours of tungsten(W)was presented for the first time.The results indicated that the selective laser melting(SLM)W exhibited a finer grain sizes,a lower strength ductility,hardness and thermal conductivity compared to hot-rolled W.The main reason for this result was that the laser underwent rapid heating and cooling when it was used to melt W powder with high energy density,resulting in large internal stress in the sample after manufacturing.Subsequently,the internal stress was released,leading to the generation of microcracks at the grain boundaries,thereby affecting the performance of SLM W samples.In addition,the higher fraction of high-angle grain boundaries(HAGBs)of SLM W was found to be the key factor for intrinsic brittleness.Because the HAGBs are the preferred crack paths,which could promote crack propagation and decrease fracture energy.