期刊文献+

在役球形储罐的焊接缺陷评定及验证性 被引量:3

Evaluation and verification of welding defects of spherical tanks in service
下载PDF
导出
摘要 在役球形储罐的定期检验中,焊缝埋藏缺陷超出相应标准时,需要按要求进行安全状况等级评定,但TSG 21—2016并未明确性质为裂纹的埋藏缺陷安全状况等级评定的相关要求。文中通过TOFD对含裂纹埋藏缺陷球形储罐进行安全评定后,选取评定图安全区域内的埋藏裂纹缺陷进行2个定期检验周期的在线监控,最终发现球形储罐使用过程中该类非活动性缺陷未发现明显扩展,解剖验证后,对裂纹未扩展原因进行了分析。文中的创新性在于将TOFD检测技术应用于球罐的埋藏缺陷的在线监测,验证了该检测方法对球罐埋藏裂纹监测方面存在一定的可行性,为同行业球罐检验提供了实践性的探索。 In the regular inspection of in-service spherical storage tanks, when the buried defect of the weld exceeds the corresponding standard, it is necessary to carry out the safety condition rating as required, but TSG 21—2016 does not specify the relevant requirements for the safety condition rating of the buried defect in the nature of the crack. In this paper, after the safety assessment of the spherical storage tank with cracked buried defects is carried out by TOFD, the buried crack defects in the safe area of the assessment map are selected for online monitoring of 2 regular inspection cycles, and finally this type of inactive defects during the use of the spherical storage tank is found. No obvious expansion was found. After anatomical verification, the reasons for the failure of the crack to expand were analyzed. The innovation of this paper lies in the application of TOFD detection technology to the online monitoring of buried defects in spherical tanks, which verifies that the detection method has certain feasibility in monitoring buried cracks in spherical tanks, and provides a practical exploration for the inspection of spherical tanks in the same industry.
作者 薛永盛 刘鹏鹏 姬辉 王峰 Xue Yongsheng;Liu Pengpeng;Ji Hui;Wang Feng(The Boiler&Pressure Vessel Safety Inspection Institute of Henan Province,Zhengzhou 450016,China)
出处 《焊接》 北大核心 2022年第8期59-64,共6页 Welding & Joining
基金 河南省科技攻关项目(202102210190) 河南省基础科研项目(2020KY27,2021KY15)。
关键词 球形储罐 在线监测 安全评定 裂纹 spherical tank on-line monitoring safety assessment crack
  • 相关文献

参考文献10

二级参考文献72

共引文献44

同被引文献19

引证文献3

二级引证文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部