Experimental Study on Tilt Adjustment Technique of Tripod Bucket Jacket Foundation for Offshore Wind Turbine in Sand

海上风电吸力式三筒导管架基础在砂土中的调平技术试验研究

For the tripod bucket jacket foundations used in offshore wind turbines, the probable critical tilt angles should be avoidedduring tilt adjustment operation. Thus, these critical values must be identified by engineers, and remedial techniques mustbe established prior to the occurrence of the problem. Model tests were carried out for typical tilting conditions of tripodbucket foundations, which were allowed to tilt freely at various penetration depths without interruption by manualoperation. After the foundation ceased its tilting, some measures, such as water pumping, water injection, air injection, or acombination of the above methods, were enabled for adjustment. The research results showed two critical values in thetilting state of the tripod bucket jacket foundation, namely the terminal and allowable angles. In the installation condition,the terminal angle was negatively correlated with the initial penetration depth, but the opposite was observed with theremoval condition. The allowable angle was less than or equal to the terminal angle. The allowable angle in the installationwas related to the terminal angle. The critical angles all varied linearly with the initial penetration depth. When tiltingduring installation, adjustment measures can be used in the order of high drum pumping, low drum water injection, highdrum pumping and low drum water injection, air injection, and exhaust. When tilting during removal, the sequential use oflow drum water injection, air, and exhaust was applied. For buckets that were sensitive to angle changes, adjustmentmeasures of the “point injection” mode can be selected.