右上中切牙全瓷冠牙体预备的轴面聚合度测量与倒凹分析

Total occlusal convergence measurement and undercut analysis of all-ceramic crown preparation of right maxillary central incisors

目的对全瓷冠牙体预备后的预备体进行多平面聚合度测量及倒凹分析,针对性指导住院医师牙体预备操作,从而提高固定修复操作技能。方法由2019~2022年在首都医科大学附属北京世纪坛医院参加规范化培训的13位住院医师按照全瓷冠的要求在仿头模标准牙颌模型上对2~3颗右上中切牙进行牙体预备,最终收集符合流程的37颗预备体。首先,分别以目测法及数码成像法判断预备体4个不同平面(近中-远中面、唇-舌面、近中唇-远中舌面和远中唇-近中舌面)轴面聚合度及倒凹;再根据数码成像法的倒凹判断结果,将预备体分为倒凹组和非倒凹组;最后分析倒凹的存在是否与预备体高度、宽度、厚度减少量和肩台宽度有相关性。结果倒凹观察分析发现目测法与数码成像法判断有差异;数码成像法对轴面聚合度测量数据显示4个不同平面预备体的倒凹率的差异有统计学意义(χ^(2)=16.188,P<0.05),采用Bonferroni校正法进行比较,唇-舌面的倒凹率高于其他平面,差异有统计学意义(P<0.05);倒凹组与非倒凹组在近中-远中面的高度及宽度减少量、唇-舌面厚度减少量,近中、远中、唇侧、舌侧肩台宽度之间的差异无统计学意义(P>0.05)。结论本研究对住院医师预备体4个不同平面的轴面聚合度进行测量,发现了预备体轴面存在倒凹的现象,使用数码成像法相比目测法可以更准确的判断倒凹和聚合度。此法可以针对性帮助住院医师提高轴面牙体预备过程的操作水平,提升固定修复操作技能。

Objective To explore the multi-plane total occlusal convergence measurement and undercut analysis of all-ceramic crown preparation.The dental preparation operation is targeted to guide residents,so as to improve the operation skills of fixed restoration.Methods Thirteen residents participated in standardized training in Beijing Shijitan Hospital Affiliated to Capital Medical University from 2019 to 2022.According to the requirement of all-ceramic crown,2-3 right maxillary central incisors were prepared on the standard tooth model of head mold.Finally,37 preparers conforming to the process were collected.Four different planes of the preparation were determined by visual and digital imaging methods(mesial-distal surface,labial-lingual surface,mesial labial-distal lingual surface,distal labial-mesial lingual surface)to measure total occlusal convergence and undercut.According to the results of the digital imaging method,the preparation was divided into undercut group and non-undercut group.Whether the existence of undercut is related to the height,width,thickness reduction and shoulder width of the preparation were analyzed.Results The analysis of undercut observation showed that there were differences between the visual method and the digital imaging method.The data of total occlusal convergence by digital imaging showed that the undercut ratio of the four different plane preparations was statistically different(χ^(2)=16.188,P<0.05).Bonferroni correction was used for comparison.The labial-lingual surface undercut ratio was higher than that of other planes(P<0.05).There was no statistical difference between the undercut group and the non-undercut group in the height and width reduction of the mesial-distal surface,the thickness reduction of the labial-lingual surface,and the shoulder width of the mesial,distal,labial and lingual sides(P>0.05).Conclusion There is undercut phenomenon in the axial plane of the preparation.Compared with the visual method,the digital imaging method could more accurately judge the degree of undercut and total occlusal convergence.