基于SolidWorks的导电胶条自动冲裁装置设计

Automatic Blanking Device for Rubber Strip Based on SolidWorks

目前,多数生产厂家切割导电胶条时采用二次冲裁的方式此方式切割效率低,且需两次定位,易造成定位偏差或胶片利用率降低。针对以上现象,设计了一种新型导电胶条自动冲裁装置。该装置能极大的提高工人的工作安全系数,有利于提高胶条冲裁效率,降低生产成本,在实际生产中具有较高的实用价值。

At present, most manufacturers use the second punching method when cutting the conductive rubber strip. This method has low cutting efficiency and requires two positioning,which is easy to cause positioning deviation or reduce the utilization rate of the film. Aiming at the above phenomenon, this work designed a new type of automatic blanking device for conductive rubber strip. The device can greatly improve the work safety factor of workers, is beneficial to improve the blanking efficiency of the rubber strip, reduce the production cost, and has high practical value in actual production.