改良全蒸发技术测量铀同位素比

Modified Total Evaporation Method for Highly Precise Measurement of Uranium Isotopes Ratio

全蒸发热表面电离质谱(TE-TIMS)是测定铀主同位素比(^(235)U/^(238)U)最经典的方法,但受限于强峰拖尾等因素影响,次同位素比(^(234)U/^(238)U、^(236)U/^(238)U)的测量精密度不高,存在偏差。本工作研究目标动态加热程序、动态和静态相结合的接收程序、强峰拖尾校正、不同接收器效率校正、质量歧视校正等,建立了改良全蒸发-热表面电离质谱技术(MTE-TIMS)高精度测定铀同位素比的方法,通过测试标准物质验证方法的准确性和可靠性。结果表明:采用MTE-TIMS法测量^(235)U丰度为2%的铀样品,其^(235)U/^(238)U、^(234)U/^(238)U和^(236)U/^(238)U的方法精密度分别为0.024%、0.06%和0.19%,测量值与参考值的偏差分别为0.025%、0.19%和0.38%。

Thermal ionization mass spectrometry(TIMS)is a well-established instrumental technique for accurately analyzing isotopes of elements with low first ionization potential.However,the measurement accuracy is affected due to the existence of the mass fractionation effect.Generally,applying the external standard method or total evaporation method is the most common way to correct the mass fractionation effect.Total evaporation(TE)technology is the most conventional method for uranium major isotope ratio measurement(^(235)U/^(238)U)using TIMS.However,due to the strong peak tailing of the major isotopes and other factors,the measurement precision and accuracy of minor isotope ratios(^(234)U/^(238)U and^(236)U/^(238)U)are relatively low.In this study,the modified total evaporation(MTE)method for highly precise measurement of uranium isotopes ratios by TIMS was developed based on the research of dynamic heating procedures,dynamic and static receiving procedures,peak tailing correction,efficiency calibration of collectors and mass discrimination calibration.The accuracy and reliability of the MTE method were verified with different reference materials.The experiment results showed that the yield of uranium oxide should be monitored and the related parameters should be precisely controlled to reduce the yield of uranium oxidation during measurement.This action could guarantee the effectiveness of the MTE measurement and improve the uranium samples utilization.The initial strength of ^(187)Re^(+) played an important role in the ionization efficiency of uranium and the yield of uranium oxide.The optimal signal of ^(187)Re^(+) should be set in the range of 0.17-0.22 V.When uranium samples with 2%235 U isotopic abundance were measured by the MTE method using TIMS,the measurement precisions of ^(235)U/^(238)U,^(234)U/^(238)U and^(236)U/^(238)U were 0.024%,0.06%,and 0.19%,and the bias between the measured value and reference value were 0.025%,0.19%,and 0.38%,respectively.Compared to the TE method,the MTE method showed the same precision for the ^(235)U/^(238)U ratio measurement.As for the MTE measurement of^(234)U/^(238)U and^(236)U/^(238)U ratios,the major uranium isotopes(235 U and^(238)U)were used as an internal standard to overcome the mass fractionation effect.When the tailing effects were eliminated,the measurement precisions of^(234)U/^(238)U and^(236)U/^(238)U ratios were improved by 5 to 10 times.As for sample amount,the TE method generally requires the uranium amount of less than 1μg,while 5μg is required for the MTE method.