摘要
在使用基于高频开关变换充电技术的充电机对脉冲电源充电时,由于充电回路中分布电感的存在,在高频电流充电过程中,会在充电机T型保护回路两端产生高于充电电压的过电压,存在损坏T型保护回路半导体功率器件的风险;为解决此问题建立充电机及脉冲电源回路仿真模型,通过仿真分析得到充电回路分布感变化对T型保护回路影响的初步规律,然后通过实验进一步验证该规律。为了减少充电回路分布电感对T型保护回路影响,针对性地提出了减少充电回路的分布电感解决方案,主要方法是改变输出线缆类型、长度等措施,并通过仿真与实验来验证该方案的有效性,为脉冲电源工程化应用提供可靠的参考依据。
When the charger based on the high-frequency switching charging technology is used to charge the pulse power supply, due to the existence of distributed inductance in the charging circuit, during the high-frequency current charging process, overvoltage higher than the charging voltage will be generated at both ends of the T-type protection circuit of the charger, and there is a risk of damaging the semiconductor power devices of the T-type protection circuit. To solve this problem, the simulation model of charger and pulse power supply circuit is established, and the preliminary law of the influence of the distribution inductance change of charging circuit on T-type protection circuit is obtained through simulation analysis, and it is further verified through experiments. To reduce the influence a solution to reduce the distributed inductance of the charging circuit is proposed. The main method is to change the type and length of the output cable. The effectiveness of the solution is verified by simulation and experiment, which provides a reliable reference for the engineering application of the pulse power supply.
作者
王毅
黄凯
苏子舟
王遂
闫杰
Wang Yi;Huang Kai;Su Zizhou;Wang Sui;Yan Jie(Northwest Institute of Mechanical&Electrical Engineering,Xianyang 712099,China)
出处
《强激光与粒子束》
CAS
CSCD
北大核心
2023年第2期130-137,共8页
High Power Laser and Particle Beams
关键词
脉冲电源
高频开关变换
T型保护回路
分布电感
过电压
pulse power supply
high frequency switching converter
T-type protection circuit
distributed inductance
overvoltage