摘要
在机械图样标注中,锥度标注是常见的零件图标注内容之一,但在UG NX12.0中并没有提供与锥度有关的标注命令,标注结果不符合国家标准。利用UG NX12.0定制符号的操作,完成了符合国家标准的锥度标注,具有一定的实用性。
In mechanical drawing annotation,taper annotation is one of the common parts drawing annotation contents,but the annotation commands related to taper are not provided in UG NX12.0,and the annotation results do not conform to the national standards.In this paper,the operation of custom symbols in UG NX12.0 is used to complete the taper annotation in accordance with the national standard,which has certain practicality.
作者
陈光霞
Chen Guangxia(School of Intelligent Manufacturing,Jianghan University,Wuhan Hubei 430056)
出处
《机械管理开发》
2023年第2期77-79,共3页
Mechanical Management and Development
关键词
UG
NX
工程图
锥度
UG NX
engineering drawing
taper
