摘要
针对高速旋转设备分布式测量需求,设计了一种单通道光纤旋转连接器(FROJ),并进行了性能测试。以此单通道FROJ为基础,采用磁光开关通过时分复用方式设计了四通道FROJ,在静态和动态条件下分别测试了其插入损耗。实验结果表明:该四通道FROJ的插入损耗小于4.5 d B,旋转变化量小于2 d B,在转速不超过600 r/min时可以实现光信号的可靠传输。
Aim at the distributed measurement requirements of high-speed rotating equipment, a single-channel fiber optic rotary joint(FROJ) is designed and its performance is tested. Based on single-channel FROJ, four-channel FROJ is designed by magneto-optical switch, and its insertion loss is tested under static and dynamic conditions. The experimental results show that the insertion loss of the four-channel FROJ is less than 4.5 dB, the rotation variation is less than 2 dB, and the reliable optical signal transmission can be realized when the speed does not exceed 600 r/min.
作者
魏莉
吴宇昌
位燕辉
WEI Li;WU Yuchang;WEI Yanhui(School of Mechanical and Electrical Engineering,Wuhan University of Technology,Wuhan 430070,China)
出处
《光通信技术》
2023年第2期64-67,共4页
Optical Communication Technology
关键词
光纤旋转连接器
磁光开关
时分复用
多通道光信号传输
分布式测量
fiber optic rotary joint
magneto-optic switch
time-division multiplexing
multi-channel optical signal transmission
distributed measurement