期刊文献+

大型真空设备中间封头与锥体焊接形式的分析探讨

Analysis and Discussion of the Form of Intermediate Head and Cone Welding of Large Vacuum Equipment
下载PDF
导出
摘要 文章基于工程实践,对工程中遇到的大型真空引射现场打压用临时封头(作为盲板)在设备锥体内焊接,将设备分割为两个独立受压室,对封头凹凸面朝向问题进行分析探讨,根据朝向得出两种焊接形式,利用ANSYS软件对封头的两种焊接形式进行了有限元分析计算,通过分析仿真计算,给出了对工程最有利的焊接形式。 Based on the engineering practice,this paper analyzes and discusses the orientation of the concave and convex surface of the head when the temporary head(as a blind plate)for the f ield pressure of the large vacuum ejector encountered in the project is welded in the equipment cone,and the equipment is divided into two independent pressure chambers.According to the orientation,two welding forms are obtained.The f inite element analysis and calculation of two welding forms of head are carried out by ANSYS software.Through the analysis and simulation calculation,the most favorable welding form for the project is given,which provides theoretical support for engineering practice and application.
作者 潘荣营 杨炼 何佳骏 PAN Rong-ying;YANG Lian;HE Jia-jun(Hangzhou Ejector Vacuum Equipment Co.,Ltd.,Hangzhou 311107,China)
出处 《化工管理》 2023年第10期137-141,共5页 Chemical Engineering Management
关键词 耐压试验 焊接接头 中间封头 打压封堵 pressure-tight test welded joint middle head blocking for pressure test
  • 相关文献

参考文献1

共引文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部