Predicting the true density of commercial biomass pellets using near-infrared hyperspectral imaging

The use of biomass is increasing because it is a form of renewable energy that provides high heating value.Rapid measurements could be used to check the quality of biomass pellets during production.This research aims to apply a near-infrared(NIR)hyperspectral imaging system for the evaluation of the true density of individual biomass pellets during the production process.Real-time measurement of the true density could be beneficial for the operation settings,such as the ratio of the binding agent to the raw material,the temperature of operation,the production rate,and the mixing ratio.The true density could also be used for rough measurement of the bulk density,which is a necessary parameter in commercial production.Therefore,knowledge of the true density is required during production in order to maintain the pellet quality as well as operation conditions.A prediction model was developed using partial least squares(PLS)regression across different wavelengths selected using different spectral pre-treatment methods and variable selection methods.After model development,the performance of the models was compared.The best model for predicting the true density of individual pellets was developed with first-derivative spectra(D1)and variables selected by the genetic algorithm(GA)method,and the number of variables was reduced from 256 to 53 wavelengths.The model gave R_(cal)^(2),R_(val)^(2),SEC,SEP,and RPD values of 0.88,0.89,0.08 g/cm^(3),0.07 g/cm^(3),and 3.04,respectively.The optimal prediction model was applied to construct distribution maps of the true density of individual biomass pellets,with the level of the predicted values displayed in colour bars.This imaging technique could be used to check visually the true density of biomass pellets during the production process for warnings to quality control equipment.