云南某铅锌矿一段磨矿介质优化

Optimization Research about Primary Grinding Medium of Lead-Zinc Ore in Yunnan

对云南某铅锌矿石测定原矿力学性质、粒度组成并通过磨矿介质的对比实验来解决其一段球磨机处理量偏低、细度不达标、产品粒度组成不合理等问题。实验结果表明,该矿石属于中硬偏软矿石,软硬分布不均匀,容重和韧性都偏高;控制工艺参数与现场接近,磨矿细度为-0.074 mm 65%时效果较佳;采用Φ80mm:Φ60mm:Φ40mm:Φ30mm=20:25:25:30钢球方案能提高磨矿效率和磨矿细度,同时降低过磨粒级含量。

Mechanical properties and particle size composition of a lead-zinc ore in Yunnan were determined,and the problems such as low processing capacity of a section ball mill,substandard fineness and unreasonable particle size composition were solved through the contrast test of grinding medium.The experimental results show that the ore is medium hard and soft ore,with uneven distribution,and high bulk density and toughness.When the grinding fineness is 65%of-0.074 mm,the best effect is obtained.Plan ofΦ80mm:Φ60mm:Φ40mm:Φ30mm=20:25:25:30 would improve grinding efficiency and grinding fineness,at the same time reduce the grinding grade levels.