摘要
利用GT-POWER软件建立柴油机原机的一维性能仿真模型,基于标定后的模型修改涡轮喷嘴环直径,在高背压条件下进行涡轮和压气机初步选型,根据选型结果开展不同涡轮和压气机组合下的性能优化匹配试验。结果表明:EF06涡轮与HF11压气机的组合在典型排气背压工况下最大可持续功率可达1665 kW,所对应的喘振裕度不低于15%。该结果证明了涡轮增压器匹配仿真及试验方法的正确性和有效性。
GT-POWER software was used to establish a one-dimensional performance simulation model of the original diesel engine.The diameter of turbine nozzle ring was modified based on the calibrated model and the preliminary selection of turbine and compressor under high back pressure was carried out.The performance optimization and matching tests using different turbine and compressor combinations were carried out according to the selection results.The results show that the maximum sustainable power with the EF06 turbine and HF11 compressor can reach 1665 kW under typical exhaust back pressure conditions,and the corresponding surge margin is no less than 15%,which proves the correctness and effectiveness of the turbocharger matching simulation and test method.
作者
戎志祥
宋大为
朱奎
李静芬
RONG Zhixiang;SONG Dawei;ZHU Kui;LI Jingfen(Shanghai Marine Diesel Engine Research Institute,Shanghai 200090,China;National Engineering Research Center of Special Equipment and Power System for Ship and Marine Engineering,Shanghai 201108,China)
出处
《柴油机》
2023年第3期49-55,共7页
Diesel Engine
基金
船舶与海洋工程特种装备和动力系统国家工程研究中心资助项目。
关键词
柴油机
增压器
排气背压
匹配
diesel engine
turbocharger
exhaust back pressure
matching
