摘要
研究了用氢氧化钾从明矾石中浸出钾,考察了搅拌速度、浸出温度、碱矿质量比和浸出时间对钾浸出率的影响,并探讨了浸出动力学。结果表明:搅拌速度900 r/min、浸出温度70℃、浸出时间30 min、碱矿质量比3/1、KOH浓度50%条件下,钾浸出率最高可达96.91%;浸出过程动力学符合表面化学反应控制模型和Avrami-Erofeev模型,表观活化能分别为41.77、40.73 kJ/mol。该法可为解决钾资源供应问题提供一种新途径。
The leaching of potassium from alunite using potassium hydroxide was studied.The effects of stirring speed,leaching temperature,alkali-mineral mass ratio and leaching time on the leaching rate of potassium were investigated.The results show that under the conditions of stirring speed of 900 r/min,leaching temperature of 70℃,leaching time of 30 min,alkali-mineral mass ratio of 3/1 and KOH concentration of 50%,the highest potassium leaching rate can reach 96.91%.The kinetics of leaching process is consistent with the surface chemical reaction control model and the Avrami-Erofeev model,and the apparent activation energies are 41.77 kJ/mol and 40.73 kJ/mol,respectively.This method can provide a new potential way to solve the problem of potassium resource supply.
作者
方小宁
匡飞
刘程琳
FANG Xiaoning;KUANG Fei;LIU Chenglin(School of Engineering,Tongren Vocational and Technical College,Tongren 010020,China;School of Chemical Engineering,East China University of Science and Technology,Shanghai 200237,China)
出处
《湿法冶金》
CAS
北大核心
2023年第5期491-496,共6页
Hydrometallurgy of China
基金
黔科合基础项目((2018)1421)。
关键词
明矾石
氢氧化钾
钾
浸出
动力学
alunite
potassium hydroxide
potassium
leaching
kinetics
