Review of All Possible Conversion Equations of Influence Coefficients with Different Formats on Two-Plane Balancing

This article lists all possible conversion equations of influence coefficients(ICs)with different formats when some of these are known to handle two-plane balancing tasks with no or less trial weight runs.There are two approaches for two-plane balancing.One can treat it as a multi-plane balance problem involving a 2×2 matrix of complex ICs where two direct ICs along with two cross-effect ICs are generated so that correction weights at one or two balance planes can be determined.One can also apply a static pare(in-phase)and/or couple pair(180 degrees out-of-phase)weights for balancing.The latter approach has been used quite often in the field,especially on steam turbine and generator rotors.Dependent on vibration mode shapes and combinations as well as balance plane accessibility,sometimes applying static or couple pair weights can be a wise choice;other times weights at one or two end planes are needed.There are totally 4 possible sets of IC data due to weights at plane 1,plane 2,static pair,and couple pair.IC data would typically be obtained by applying trial weights followed by trial weight runs.It is found,however,that all these IC data can be converted easily without trial weight runs once any two of 4 sets are known.The above findings and conversion equations have been obtained analytically and verified by experimental results.Real cases are given to demonstratetheirapplications.