期刊文献+

多室内环流反应器中液体循环量的试验验证与模拟

Experimental verification and simulation of liquid circulation in multi-chamber loop reactor
下载PDF
导出
摘要 目的对液相氧化脱硫多室内环流反应器液体循环量的影响因素进行模拟和验证。方法采用CFD数值模拟,基于欧拉-欧拉多相流模型,对液相氧化脱硫多室内环流反应器进行气液两相流模拟,考查了酸气流量和空气流量对液体循环量的影响。结果利用数值模拟得到的液体循环量与利用靶式流量计测得的液体循环量误差小于10%。当酸气中H 2S体积分数不超过3%时,液体循环量(z)与酸气流量(x)、空气流量(y)之间的关系式为:z=-474.996+0.358 x+0.4873 y。结论欧拉-欧拉两相流模型能够准确地预测液相氧化脱硫反应器内液体循环量。 Objective The aim is to simulate and verify the influencing factors of liquid circulation in liquid phase oxidation desulfurization multi-champer loop reactor.Methods Based on the Euler-Euler multi-phase flow model,the gas-liquid two-phase flow in the liquid phase oxidation desulfurization multi-champer loop reactor was simulated by CFD numerical simulation,and the effects of acid gas volume flow and air volume flow on liquid circulation were investigated.Results The error between the liquid circulation obtained by numerical simulation and the liquid circulation measured by the target flow meter was less than 10%.When the volume fraction of hydrogen sulfide in acid gas did not exceed 3%,the correlation between the liquid circulation(z),acid gas volume flow(x)and air volume flow(y)was as follows:z=-474.996+0.358 x+0.4873 y.Conclusion The Euler-Euler two-phase flow model can accurately predict the liquid circulation in the liquid phase oxidation desulfurization reactor.
作者 鲁盼盼 孙美露 李新 崔虎 高春华 杨维立 翟瑞国 LU Panpan;SUN Meilu;LI Xin;CUI Hu;GAO Chunhua;YANG Weili;ZHAI Ruiguo(Tianyan Fine Chemistry Technology Co.,Ltd.,Ningbo,Zhejiang,China;PetroChina Changqing Oilfield Company,Xi′an,Shaanxi,China;School of Chemical Engineering and Technology,Tianjin University,Tianjin,China)
出处 《石油与天然气化工》 CAS CSCD 北大核心 2024年第2期34-38,共5页 Chemical engineering of oil & gas
关键词 液相氧化脱硫 多室内环流反应器 数值模拟 液体循环量 酸气流量 空气流量 liquid phase oxidation desulfurization multi-chamber loop reactor numerical simulation liquid circulation acid gas volume flow air volume flow
  • 相关文献

参考文献3

二级参考文献20

共引文献73

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部