Integrated Test System for Large-aperture Telescopes Based on Astrophotonics Interconnections

This study aims to improve the integrated testing of large-aperture telescopes to clarify the fundamental principles of an integrated testing system based on astrophotonics.Our demonstration and analyses focused on element-position sensing and modulation based on spatial near-geometric beams,high-throughput step-difference measurements based on channel spectroscopy,distributed broadband-transmittance testing,and standard spectral tests based on near-field energy regulation.Comprehensive analyses and experiments were conducted to confirm the feasibility of the proposed system in the integrated testing process of large-aperture telescopes.The results demonstrated that the angular resolution of the light rays exceeded 5arcsec,which satisfies the requirements for component-position detection in future large-aperture telescopes.The measurement resolution of the wavefront tilt was better than 0.45μrad.Based on the channel spectral method—which combined a high signal-to-noise ratio and high sensitivity,along with continuous-spectral digital segmentation and narrowband-spectral physical segmentation—a resolution of 0.050μm and a range of 50μm were obtained.After calibration,the measurement resolution of the pupil deviation improved to exceed 4%accuracy,and the transmission measurements achieved a consistency of over 2%accuracy.Regarding fringe-broadband interferometry measurements,the system maintained high stability,ensuring its operation within the coherence length,and robustly detected the energy without unwrapping the phase.The use of a projector for calibrating broadband-spectrum measurements led to a reduction in contrast from 0.8142 to 0.6038,which further validates the system's applicability in the integrated testing process of large-aperture telescopes.This study greatly enhanced the observational capabilities of large-aperture telescopes while reducing the integrated system's volume,weight,and power consumption.