期刊文献+

Evolution of MnO–SiO2–Al_(2)O_(3)–MgO inclusions during heat treatment at 1100℃

原文传递
导出
摘要 To investigate the evolutionary behavior of the MnO–SiO_(2)–Al_(2)O_(3)–MgO inclusions during heat treatment,water quenched samples were isothermally held at 1100°C for 120 min in Ar and air atmosphere,and the obtaining samples were analyzed by X-ray diffraction,scanning electron microscopy and energy dispersive spectrometer.It showed that 3MnO·Al_(2)O_(3)·3SiO_(2)and MnO·SiO_(2)were detected in the 5 wt.%MgO system after isothermal holding in Ar atmosphere,while MgO·Al_(2)O_(3),MnO·SiO_(2)and Mn7O8·SiO4 were detected in air atmosphere.The evolutionary behavior of the 10,15 and 20 wt.%MgO systems after isothermal holding in different atmosphere were consistent.Oxygen affected the solid phase transformation of the low MgO content systems.The calculation results of FactSage 8.1 showed that MgO·Al_(2)O_(3)was formed in the 5 wt.%MgO system with air atmosphere.The solid phase transformation was accompanied by grain coarsening during the isothermal holding process.The differences in the solid phase transformation in different atmosphere of the 5 wt.%MgO system indicated that it was a gas-phase transport grain coarsening mechanism.The enrichment of Al element in the liquid phase region at the grain edges,the homogeneous distribution of Mg element and the disappearance of the liquid phase within the crystal revealed that other MgO content systems were liquid–solid transport grain coarsening mechanism.
出处 《Journal of Iron and Steel Research(International)》 SCIE EI CAS CSCD 2024年第5期1221-1231,共11页 钢铁研究学报(英文版)
基金 supported by the National Natural Science Foundation of China(Nos.52274341 and 51974210).
  • 相关文献

参考文献1

二级参考文献16

  • 1Standardization Administration of China, Wire Rod for Steel Cord, China, GB/T27691-2011, 2011.
  • 2F. S. Pan, A.T. Tang, K. Li, Titanium Carbonitride and Its Reactive Synthesis of Composites, Chongqing University Press, Chongqing, 2005.
  • 3J. Zhang, Z. L. Xue, Y. D. Jiang, J. L. Lei, F. Zou, R. Xiong, Metal. Int. 19 (2014) No.l, 34-37.
  • 4X. S. Jiang, Non[errous Inclusion in Steel, Metallurgical Indus- try Press, Belling, China, 2011.
  • 5H. T. Zhan, Technology Optimization and Quality Improvement of Tire Cord Steel Production, Wuhan Univ. Sci. Technol., Wu han, 2014.
  • 6Y. D. Jiang, Z. L. Xue, J. Zhang, J. Iron Steel Res. Int. 21 (2014) Suppl. 1, 91-94.
  • 7J. L. Lei, Z. L. Xue, Y. D. Jiang, J. Zhang, T. T. Zhu, Metal. Int. 17 (2012) No. 9, 10 15.
  • 8Q. L. Yong, B. R. Wu, Z.B. Sun, G.J. Wang, J. Iron Steel Res. Int. 1 (1989) No. 4, 48 52.
  • 9Y. Qu, Principle of Steelmaking, Metallurgical Industry Press, Belling, China, 1992.
  • 10J. X. Chen, The Handbook of Chart and Data Commonly Used in Steelmaking, Metallurgical Industry Press, Belling, China, 1984.

共引文献2

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部