期刊文献+

石墨烯-MnBi_(2)Te_(4)异质结室温高灵敏度太赫兹探测器

High-sensitivity room-temperature terahertz detector with graphene-MnBi_(2)Te_(4) heterostructure
下载PDF
导出
摘要 太赫兹技术因其在医学成像、深空探索、无线通信、无损检测等领域的应用前景而受到广泛关注。然而,常温条件下对太赫兹辐射进行高灵敏度检测仍然是一个极大的技术挑战。文中利用低热导率的磁性拓扑绝缘体MnBi_(2)Te_(4)与高热导率的石墨烯形成范德华异质结,进而构建了一种异质结结构的太赫兹探测器。室温条件下,在0.04 THz与0.12 THz的频率太赫兹辐射照射下,探测器展现出超快的光电响应速度(16μs)和较高的响应度(0.43 mA/W和4.61 mA/W),同时具备较低的噪声等效功率(2.04 nW/Hz^(1/2)和190.58 pW/Hz^(1/2))。结果表明,基于石墨烯-MnBi_(2)Te_(4)异质结的太赫兹探测器在太赫兹探测领域具有巨大的应用潜力。 Objective Terahertz radiation,which lies between microwaves and infrared in the electromagnetic spectrum combines the penetration ability of microwaves with the high resolution of optical waves.This unique spectra position endows terahertz radiation with enormous potential for applications across various fields such as biomedical imaging,national security surveillance,next-generation wireless communication and non-destructive testing.The terahertz detector is the core component of a terahertz detection system,responsible for transforming terahertz radiation into electrical signals.Existing terahertz detection technologies suffer from high costs,slow response times,dependency on low-temperature conditions and high power consumption.To overcome these challenges,the development of a room-temperature terahertz detector that is highly sensitive,rapidly responsive and energy-efficient has become imperative.The study presented introduces a heterostructure terahertz detector based on a novel topological magnetic insulator,MnBi_(2)Te_(4),and graphene.By exploiting the photothermoelectric effect,the detector achieves high sensitivity,swift response,and low power consumption at room temperature.Methods Ultraviolet lithography was first employed to create electrode structures on an intrinsic silicon substrate (ρ>10 000Ω·cm),followed by the deposition of 10 nm of titanium (Ti) and 50 nm of gold (Au) via electron beam evaporation.After the metal electrodes were fabricated using a lift-off process,graphene and MnBi_(2)Te_(4) flakes were exfoliated by mechanical exfoliation and subsequently transferred onto the metal electrodes in sequence through a dry transfer method.In this design,the metal electrodes functioned both as conduits for electric current and as antennas for the efficient coupling of terahertz waves.When terahertz radiation was incident on the bow-tie antenna,a significant enhancement in the light absorption efficiency within the device channel was observed.For this reason,the geometric parameters of the bow-tie antenna were simulated and optimized for a terahertz source with a central frequency of 0.12 THz using the finite-difference time-domain method.After the fabrication was completed,the photovoltaic response of the heterostructure device was tested under room temperature and atmospheric conditions.The terahertz response current was amplified by a preamplifier and finally read out with a lock-in amplifier.Results and Discussions At room temperature,the terahertz detector based on graphene and the magnetic topological insulator MnBi_(2)Te_(4) demonstrated an ultrafast photoelectric response time of 16μs (as seen in Fig.2(c))at frequencies of 0.04 THz and 0.12 THz,with responsivities reaching up to 0.43 mA/W and 14.37 mA/W (as shown in Fig.3),along with a comparatively low noise-equivalent power.The detector operates on the principle of thermally exciting the carriers within the graphene-MnBi_(2)Te_(4) heterojunction due to incident terahertz radiation The differences in thermal conductivity,light absorption,and the Seebeck coefficient between the two materials create a temperature gradient that drives the carriers to move,forming a thermoelectric potential difference and effectively converting terahertz radiation into an electrical signal.The imaging results obtained from the terahertz imaging system constructed in the laboratory (as shown in Fig.5(c)) validate the performance of the detector when integrated into the system.Conclusions In this study,a heterostructure of graphene and MnBi_(2)Te_(4) was designed to harness the synergistic effects arising from the combination of these two materials.Based on the photothermoelectric effect,the detector exhibited exceptional terahertz detection capabilities in a self-driven mode without the need for an external bias At room temperature,the device demonstrated high responsivity,ultra-short photoresponse times,and lower noise-equivalent power at frequencies of 0.04 THz and 0.12 THz.These findings suggest that the heterojunction devices composed of the magnetic topological insulator MnBi_(2)Te_(4) and graphene hold significant potential for development in the field of terahertz detection.
作者 胡臻智 刘肇国 周桓立 杨宗儒 宋元军 张晓阳 张彤 HU Zhenzhi;LIU Zhaoguo;ZHOU Huanli;YANG Zongru;SONG Yuanjun;ZHANG Xiaoyang;ZHANG Tong(Key Laboratory of Micro-Inertial Instrument and Advanced Navigation Technology,Ministry of Education,School of Instrument Science and Engineering,Southeast University,Nanjing 210096,China;Joint International Research Laboratory of Information Display and Visualization,School of Electronic Science and Engineering,Southeast University,Nanjing 210096,China;Suzhou Key Laboratory of Metal Nano-Optoelectronic Technology,Southeast University Suzhou Campus,Suzhou 215123,China)
出处 《红外与激光工程》 EI CSCD 北大核心 2024年第7期226-233,共8页 Infrared and Laser Engineering
基金 国家重点研发计划项目(2021YFB2800700)。
关键词 太赫兹探测器 光热电效应 拓扑绝缘体 范德华异质结 terahertz detector photothermoelectric effect topological insulator Van der Waals heterostructure
  • 相关文献

参考文献2

二级参考文献4

共引文献6

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部