摘要
《临汾市2019年钢铁、焦化行业深度减排工作方案》要求炭黑烟气实现超低排放准,排放烟气在基准氧体积分数按3.5%(干基)折算时的排放指标:NO_(x)排放质量浓度≤50mg/m^(3),SO_(2)排放质量浓度≤35mg/m^(3),烟尘排放质量浓度≤10 mg/m^(3),为此必须进行炭黑烟气脱硫脱硝除尘深度治理,实现超低排放,以满足目前环保的要求。通过对项目改造方案比选,最终确定采用SCR脱硝+SDS干法脱硫+布袋除尘器的工艺路线。改造实施后,对项目试运行中出现的问题进行了优化改造,使脱硫脱硝装置达到了预期效果。
The 2019 Deep Emission Reduction Work Plan for the Steel and Coking Industry in Linfen City requires that carbon black flue gas achieve ultra-low emission standards.The emission indicators of the flue gas when converted to 3.5%(dry basis)of the benchmark oxygen volume fraction are:NO_(x) emission mass concentration≤50 mg/m^(3),SO_(2) emission mass concentration≤35 mg/m^(3),and smoke emission mass concentration≤10 mg/m^(3).Therefore,deep treatment of carbon black flue gas desulfurization,denitrification,and dust removal must be carried out to achieve ultra-low emissions and meet current environmental protection requirements.After comparing and selecting the project renovation plan,the process route of SCR denitrification+SDS dry desulfurization+bag filter was finally determined.After the implementation of the renovation,optimization and renovation were carried out on the problems that occurred during the trial operation of the project,which enabled the desulfurization and denitrification device to achieve the expected results.
作者
郭雪婷
Guo Xueting(Shanxi Coking Co.,Ltd.,Linfen Shanxi 041606,China)
出处
《山西化工》
CAS
2024年第7期262-264,共3页
Shanxi Chemical Industry
关键词
深度减排
脱硫脱硝
超低排放
deep emission reduction
desulfurization and denitrification
ultra low emissions