摘要
在水处理领域,管路铺设和流向控制至关重要。合理的管路铺设和流向控制,能够节省空间、实现集中控制和满足多样化安装场景需求。为此,设计一款多管道水流控制装置,实现水处理设备管路间的协同作业。首先,根据不同管路需求,采用Solidworks软件设计多管道水流控制装置。其次,利用Inspire有限元分析软件进行流体仿真,得出80 s前参数变化较大、80 s后水流趋向稳定的分布规律。最后,运用增材制造技术打印出相关零部件并进行装配,进行通流检验,验证设计的可行性。
In the field of water treatment,piping and flow control are crucial.Proper pipe laying and flow direction control can save space,implement centralized control,and meet diverse installation scenarios.Therefore,a multi-pipe water flow control device is designed to realize the cooperative operation between the pipes of water treatment equipment.First,according to different pipeline requirements,the multi-pipeline flow control device is designed using Solidworks software.Secondly,Inspire finite element analysis software is used for fluid simulation,and the distribution law of water flow tends to be stable after 80 s while the parameters changed greatly before 80 s.Finally,the additive manufacturing technology is used to print out the relevant parts and assemble them,and then the flow test is carried out to verify the feasibility of the design.
作者
肖志玲
张玉浩
王爱民
王崇占
刘博
李建涛
白家帅
黄剑坡
张莉
XIAO Zhiling;ZHANG Yuhao;WANG Aimin;WANG Chongzhan;LIU Bo;LI Jiantao;BAI Jiashuai;HUANG Jianpo;ZHANG Li(School of Materials Science and Engineering,Tianjin University,Tianjin 300350;College of Mechanical and Electrical Engineering,Zhengzhou University of Light Industry,Zhengzhou 450002;Sijin Intelligent Forming Machinery Co.,Ltd,Ningbo 453499;Department of Mechanical Engineering,Zhengzhou University of Science and Technology,Zhengzhou 450064)
出处
《现代制造技术与装备》
2024年第9期24-28,共5页
Modern Manufacturing Technology and Equipment
基金
河南省重点研发专项“复杂工况下盾构工程刀具增强用超硬复合涂层与制品关键制备技术及应用”(231111231200)
河南省科技攻关项目“光伏并网逆变器单双级MPPT混合算法研究与应用”(242102240121)。
关键词
管路铺设
流向控制
流体仿真
增材制造
水处理
pipeline laying
flow direction control
fluid simulation
additive manufacturing
water treatment
