期刊文献+

极地钻井液冷却用板式换热器设计及换热性能模拟研究

Design of a plate heat exchanger for cooling drilling fluid in polar regions and numerical simulation on its heat transfer performance
下载PDF
导出
摘要 在极地开展冰下基岩取心钻探,对研究冰下地质构造、揭示冰盖演化历史、评估未来气候变化等均有重要的意义。在极地冰下基岩钻探过程中,钻井液在孔底循环后温度可能升高至0℃以上,进而在上返过程中融化冰孔孔壁,导致井壁失稳,甚至引发卡钻事故。为此,有必要研发极地钻井液冷却系统,在地表将钻井液冷却至较低的温度后再注入孔内,进而使钻井液在循环过程中始终保持在0℃以下。换热器是钻井液冷却系统的核心部件。本文选用板式换热器做为钻井液的换热部件,采用平均温差法确定了板式换热器的换热面积和基本参数,然后使用COMSOL Multiphysics 6.0软件对板式换热器的换热性能进行了数值模拟。研究结果表明,该换热器可将钻井液冷却至-4~-3℃;此外,模拟结果表明,钻井液的出口温度随载冷剂注入温度的降低和载冷剂流量的增大而降低;钻井液的类型对换热器的换热性能有较大影响,而换热板片的材质对换热器的换热效果影响不大。 It is of great significance to carry out subglacial bedrock core drilling in polar regions for studying subglacial geology,revealing the evolutionary history of ice sheets and evaluating future climate change.The temperature of the drilling fluid may rise above 0°C after circulating at the bottom of the hole When drilling subglacial bedrock in polar regions,which may cause the wall of the icy hole to be melted during upward return,resulting in the instability of the wall,and even triggering the stuck drilling accident.It is necessary to design a drilling fluid cooling system that cooling the drilling fluid to a lower temperature before injecting it into the borehole,thereby keeping the drilling fluid below 0℃at all times during circulation.The heat exchanger is the core component of the drilling fluid cooling system.The paper selects plate heat exchanger as the heat exchange component to cool drilling fluid,and uses the average temperature difference method to determine the heat exchange area and basic parameters,then numerical simulation of the heat exchange performance of the plate heat exchanger is using COMSOL Multiphysics 6.0 software.The research results show that the heat exchanger can cool the drilling fluid to-4~-3℃.Further,the simulation results show that the outlet temperature of the drilling fluid decreases with the decrease of the carrier refrigerant injection temperature and the increase of the carrier refrigerant flow rate,the type of drilling fluid has a great influence on the heat transfer performance of the heat exchanger,while the material of the heat exchanger plate has little influence.
作者 王祖凡 李亚洲 杨甘生 张凯 王晋 周正 WANG Zufan;LI Yazhou;YANG Gansheng;ZHANG Kai;WANG Jin;ZHOU Zheng(School of Engineering and Technology,China University of Geosciences(Beijing),Beijing 100083,China;Key Laboratory of Polar Geology and Marine Mineral Resources(China University of Geosciences,Beijing),Ministry of Education,Beijing 100083,China)
出处 《钻探工程》 2024年第5期59-67,共9页 Drilling Engineering
基金 国家重点研发计划项目“南极冰下复杂地质环境多工艺钻探理论与方法”课题四“多工艺极地钻探装备研发与系统集成”(编号:2021YFA0719104) 中央高校基本科研业务经费项目“可回收式热融钻具孔内融水与周围冰层传热机理”(编号:2-9-2021-017)。
关键词 极地钻探 冰下基岩取心 钻井液 冷却系统 板式换热器 polar regions drilling subglacical bedrock core drilling drilling fluid cooling system plate heat exchanger
  • 相关文献

参考文献3

二级参考文献39

  • 1焦安军,丁一冰,陈长青.板翅式换热器导流片导流性能的实验研究[J].低温工程,1995(5):27-32. 被引量:11
  • 2陈叔平,昌锟,刘振全,苏海林,谢高峰,陈光奇,陈联.低温翅片管换热器的传热试验研究[J].低温与超导,2006,34(2):91-93. 被引量:14
  • 3张平亮.新型高效换热器的技术进展及其应用[J].压力容器,1997,14(2):56-62. 被引量:29
  • 4陈树军,汪荣顺,石玉美.CGSE中液位指示稳定的低温沸腾换热器的设计[J].低温与超导,2007,35(3):197-200. 被引量:1
  • 5O. ALEMANY, H. MITYAR. Viscosity and Density of a Two- phase Drilling Fluid[ Jl. Annals of Glaciology,2007,47 ( 1 ) :141 - 146.
  • 6P.G. Talalay. Subglacial Till and Bedrock Drilling[ J ]. Cold Re- gions Science and Technology,2013,86 : 142 - 166.
  • 7P.G. TALALAY, N.S. GUNDERSTRUP. Hydrostatic Pressure and Fluid Density Profile in Deep Ice Bore-holes[ J]. National In- stitute of Polar Research. 2002,56 : 171 - 180.
  • 8P.G. TALALAY. Dimethyl Siloxane Oils as an Alternative Bore- hole Fluid, USA [ J ]. Annals of Glaciology, 2007,47 ( 1 ) : 82 - 88.
  • 9P. G. TALALAY, N.S. UNDERSTRUP. Hole Fluids for Deep Ice Core Drilling[ J]. National Institute of Polar Research,2002,56: 148 - 170.
  • 10郭佳,崔国民,高孝忠,等.多股流换热器通道排列连续性序列的生成方法[C].广州:2007年传热传质学学术会议论文集.2007,1855-1858.

共引文献18

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部