期刊文献+

Zn 对免热处理铸造铝硅系合金显微组织与力学性能的影响

Effect of Zn on the Microstructure and Mechanical Properties of Al-Si Non-Heat Treatment Alloy
下载PDF
导出
摘要 研究了Zn元素含量分别为0.5wt%、1.0wt%、和1.5wt%时,对Al-Si-Mn-Mg免热处理铸造铝合金的显微组织和力学性能影响。通过变质处理,观察到不同的微观组织。结果表明,随着Zn元素含量的提高,合金的抗拉强度及屈服强度增加,伸长率降低。同时发现,随着Zn元素含量的提升,合金的变质效果出现不同程度的下降。 The effects of Zn content of 0.5wt%,1.0wt%,and 1.5wt%on the microstructure and mechanical properties of Al Si Mn Mg heat free cast aluminum alloy were studied.By metamorphism,different microstructures were observed.The results indicate that with the increase of Zn element content,the tensile strength and yield strength of the alloy increase,while the elongation rate decreases.At the same time,it was found that with the increase of Zn element content,the modification effect of the alloy decreased in different degrees.
作者 李明 常博文 刘志中 李宇飞 刘家懿 康明 姜正鳌 LI Ming;CHANG Bo-wen;LIU Zhi-zhong;LI Yu-fei;LIU Jia-yi;KANG Ming;JIANG Zheng-ao(The Forth Naval Military Representative Office in Shenyang District,Shenyang 110022,Liaoning,China;National Key Laboratory of Advanced Casting Technologies,Shenyang Research Institute of Foundry Co.,Ltd.,CAM,Shenyang 110022,Liaoning,China;Shenyang Research Institute of Foundry Co.,Ltd.,CAM Shenyang 110022,Liaoning,China;Shenyang Zhuyan Technology Co.,Ltd.,Shenyang 110022,Liaoning,China)
出处 《铸造》 CAS 2024年第9期1243-1247,共5页 Foundry
关键词 显微组织 铝合金 铸造铝合金 合金化 免热处理 microstructure aluminum alloy casting aluminum alloy alloying non-heat treatment
  • 相关文献

参考文献6

二级参考文献45

共引文献34

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部