复杂地表环境下永久散射体的选取方法

STUDY ON PS POINT SELECTION METHOD IN COMPLEX SURFACE ENVIRONMENT

利用PSInSAR(Permanent Scatter Interferometric Synthetic Aperture Radar)监测地表形变的关键在于PS(Permanent Scatter)点的质量。在断裂带地区常因自然地表覆盖复杂、地质地貌环境特殊导致无法准确提取到高质量的PS点,这限制了该技术在断裂震间形变监测中的应用。针对断裂带高质量PS选点问题,文中在常规相干系数选点法的基础上,试验结合振幅离差、KS(Kolmogorov-Smirnov)双样本检验及提出的CR同质像元法,在设定相干系数阈值、振幅离差阈值后再加设KS检验、CR同质像元阈值进行对比研究。以2015年3月14日-2020年2月16日的Sentinel-1ASAR影像为数据源,以青藏高原东北缘西秦岭北缘断裂带武山-甘谷段为试验区进行了PSInSAR处理,对比分析各方法的PS选点质量及可靠性。结果表明,将相干系数、振幅离差及CR同质像元结合的三阈值筛选方法更适用于地表环境复杂的断裂带地区,武山-甘谷段南、北两盘的相对平均形变速率约为0.7mm/a,为左旋走滑趋势。

The key challenge of PSInSAR(Permanent Scatter Interferometric Synthetic Aperture Radar)lies in the quality of Permanent Scatter(PS)points,which are difficult to extract accurately in fracture zones due to the complex natural ground cover and unique geomorphological environments.In such areas,the inability to reliably extract high-quality PS points limits the application of PSInSAR for monitoring interseismic deformation.To address the problem of high-quality PS point selection in fault zones and improve the effectiveness of PSInSAR technology for monitoring interseismic deformation,this paper presents a comparative study of coherence coefficient and amplitude deviation double thresholds.The study further integrates the Kolmogorov-Smirnov(KS)test and CR homogeneous pixel method,in addition to conventional coherence coefficient point selection techniques.Sentinel-1A SAR images from March 14,2015,to February 16,2020,are used as the data source,with the Wushan-Gangu section of the fault zone on the northern edge of the Western Qinling Mountains,near the northeastern edge of the Qinghai-Tibet Plateau,serving as the test area for PSInSAR processing.The quality and reliability of PS point selection using various methods are compared and analyzed.Two sets of coherence coefficient Tγand amplitude deviation Dγdouble thresholds were tested.The coherence coefficient was set at Tγ=0.5,while the amplitude deviation Dγwas set to 0.5 and 0.3,resulting in 19806 and 2485 PS points,respectively.When the amplitude deviation threshold was lowered,the number of PS points on ridgelines decreased significantly,while there was little change in Gangu County,suggesting poor pixel amplitude stability in mountainous areas.Lowering the threshold eliminated many PS points,retaining only those with high amplitude and stable time series,typically found in hard targets like urban buildings.A KS double sample test was then applied in combination with the double threshold method,with all thresholds coefficient Tγ,amplitude deviation Dγ,and KS test Pγset at 0.5.This approach yielded 1313 PS points,showing a significant reduction in PS points on ridgelines and in Gangu County,while urban points became more concentrated on hard targets like buildings.Although the KS test reduced PS points in vegetated areas,it did not fully eliminate noise points.Finally,based on the double threshold results of coherence coefficient Tγ=0.5 and amplitude deviation Dγ=0.3,both the KS test and CR homogeneous pixel selection methods were applied.The CR homogeneous pixel method used a phase difference threshold Pγ=0.5 and a temporal phase stability threshold Nγ=50.This yielded 2485 PS points for the double threshold method,133 PS points for the double threshold plus KS test,and 414 PS points for the double threshold plus CR homogeneous pixel method.The latter two methods significantly reduced PS points,with a higher concentration of points in Gangu County,consistent with the expectation that PS points predominantly correspond to hard targets like buildings.Statistical analysis of the results demonstrated that the combination of the coherence coefficient,amplitude deviation,and CR homogeneous pixel method provided the highest quality PS points,effectively excluding noise points in vegetated areas.The combination of coherence coefficient,amplitude deviation,and KS test ranked second,improving accuracy in urban areas but failing to eliminate noise in vegetated areas.Using Sentinel-1A SAR images and the Wushan-Gangu fault as the test area for time series PSInSAR processing,the accuracy of PS point selection was further verified.A comparative analysis of deformation monitoring results from the three methods revealed that both the KS test and CR homogeneous pixel method improved the accuracy of fault deformation monitoring,with the CR homogeneous pixel method yielding superior results.Monitoring data from 2015 to 2020 showed that the deformation rate of the northern block of the Wushan-Gangu fault ranged from-2 to-0.2mm/a,with an average deformation of approximately-1.7mm/a.In contrast,the southern block exhibited a deformation rate between 0.3 and 0.5mm/a,with an average deformation of about 1.8mm/a The relative average deformation rate between the northern and southern blocks was 0.7mm/a,indicating left-lateral strike-slip movement.Among the three methods,the double threshold plus CR homogeneous pixel method produced PS points with the smallest deformation rate standard deviation,indicating more stable and reliable deformation results.