摘要
304不锈钢应用在某些精密零件上时往往需要将材料超薄化处理,因此研究超薄304不锈钢金属箔的成形性能十分有意义。以微米级厚度的304不锈钢金属箔为研究材料,研究摩擦因数、厚度异向系数及压边力对30、60、100μm这3种厚度试件的成形性能的影响。通过拉伸试验获取3种不同厚度试件的力学参数,再将所获得的力学参数输入LS-DYNA有限元软件进行仿真,用杯突试验验证仿真结果,两者具有一致性。通过有限元仿真研究试件成形性能的影响因素,结果表明摩擦因数越小、厚度异向系数越大,在一定范围内压边力越小试件成形性能越好。最后采用光刻法对超薄金属箔材料进行网格印制,并以60μm厚度的试件为例绘制成形极限图。
The utilization of 304 stainless steel in certain precision components often necessitates meticulous treatment of the material to achieve ultra-thin dimensions.Consequently,exploring the forming behavior of ultra-thin 304 stainless steel metal foil holds significant importance.304 stainless steel foil with micron thickness is used as the research material to study the influence of friction coefficient,thickness anisotropy index and blank holder force on the forming performance of 30,60 and 100μm thickness specimens.The mechanical parameters of three different thickness specimens are obtained by tensile test,and then the obtained mechanical parameters are input into LS-DYNA finite element software for simulation.The simulation results were verified by the cupping test,and the two were consistent.The influence factors of the forming performance of the specimen are studied by finite element simulation.The results show that the smaller the friction coefficient,the larger the thickness anisotropy index,and the smaller the blank holder force in a certain range,the better the forming performance of the specimen.Finally,the lithography method is used to print the grid of the ultra-thin metal foil material,and the forming limit diagram is drawn by taking the 60μm thickness specimen as an example.
作者
汤秀佳
张莹
TANG Xiujia;ZHANG Ying(Department of Electromechanical and Vehicle Engineering,Taiyuan University,Taiyuan 030032,CHN;Department of Electromechanical and Vehicle Engineering,Shandong Jianzhu University,Jinan 250101,CHN)
出处
《制造技术与机床》
北大核心
2024年第12期112-119,共8页
Manufacturing Technology & Machine Tool
基金
山西省高等学校科技创新计划项目“汽车空调风机多元耦合仿生降噪机理研究”(2023L387)。
